User Manual

8 Extra information
WATER HARDNESS LEVEL SETTINGS (SALT CONSUMPTION)
Level German hardness
[dH]
French hardness
[dF]
British hardness [dE] Display indicator
1 0-5 0-9 0-6 L1
2 6-11 10-20 7-14 L2
3 12-17 21-30 15-21 L3
4 18-22 31-40 22-28 L4
5 23-31 41-55 29-39 L5
6 32-50 56-90 40-63 L6
RINSE AID CONSUMPTION SETTINGS
Level Number of rinse aid doses that is dispensed Display indicator
1 Rinse aid not dispensed r1
2 1 dose r2
3 2 doses r3
4 3 doses r4
5 4 doses r5
9 Troubleshooting
GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the fault codes.
2. If you cannot find a solution for the problem, reset the appliance. Refer to section
'Resetting the program' .
3. If the fault code keeps re-occuring, contact the Inventum-servicedienst.
TROUBLESHOOTING TABLE
Problem Possible cause Possible solution
The program does not start. The mains plug is not connected. Connect the mains plug.
There is a problem with the fuse. Do a check on the fuse box.
There is no water supply. Open the water tap.
The door of the appliance is open. Close the door.
The appliance is switched off. Start the appliance. Refer to section
'Starting the appliance' .
The water inlet hose and filters are
clogged.
Make sure that the water inlet hose
and the filters are not clogged.
The detergent reservoir contains
detergent residues.
The detergent reservoir is filled while
the reservoir was still damp.
Make sure that you fill the detergent
reservoir when it is dry.
English • 53