User Manual

Problem Possible cause Possible solution
The appliance contains water when
the program is finished.
The drain hose is clogged or twisted.
• Make sure that the drain hose is
not clogged.
• Make sure that the drain hose is
not twisted.
The filters are clogged. Clean the filters. Refer to section
'Cleaning the filters' .
The program has not finished. Wait until the program is finished.
A buzzer sounds five times and the
ready indicator is on when a program
is finished.
The appliance stops during a
program.
There is a power failure. Make sure that there is power.
There is a water inlet failure. Make sure that there is water inlet
supply.
The appliance makes unusual
sounds during a program.
One of the spray arms hits the
dishes.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance' .
There is food waste left on the
dishes.
The appliance is not loaded correctly
and the spray arms cannot reach all
the dishes.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance' .
The appliance is not loaded
correctly.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance' .
The amount of detergent is
insufficient.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
'Filling
the detergent reservoir'
.
The selected program is not suitable
for the loaded dishes.
Choose a suitable program. Refer to
section
'Programs' .
One of the spray arms is clogged. Clean the spray arms. Refer to
section
'Cleaning the spray arms' .
The filters are clogged. Clean the filters. Refer to section
'Cleaning the filters' .
The filters are not placed correctly. Make sure that you correctly place
the filters.
The water drain pump is clogged. Make sure that the water drain pump
is not clogged.
There are white stains on the dishes. The amount of detergent is
insufficient.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
'Filling
the detergent reservoir'
.
The level of rinse aid consumption is
set too low.
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
There is a high level of water
hardness and no salt is used.
Fill the salt reservoir. Refer to
section
'Filling the salt reservoir' .
The cap of the salt reservoir is not
closed correctly.
Make sure that the cap of the salt
reservoir is closed firmly.
54 • English