Operation Manual

En
11
5.2.8 Ethernet
Note: this menu is showed only when the TS/IP streaming is installed and the board is set to “IP Out”, refer to
section ‘Optional Function’ for how to set up.
The TS/IP Ethernet connector could also be congured as the output of the transport stream over IP. The
parameters listed below must be set to appropriate values for the network over which the transport stream over
IP is broadcasted.
Stream IP Addr:
• Enter the IP address for streaming IP output of the unit.
Stream Netmask:• Enter the network sub mask for the subnet to which the unit is connected for IP
streaming trafc.
Stream Gateway:• Set the gateway for the network to which the unit is connected for IP streaming trafc.
Stream Mac Address:• factory-set MAC addresses are guaranteed to unique. Therefore you cannot
congure the address.
Protocol: • select the protocol for multicast: UDP or RTP.
TS Pkts Per UDP:• set the number of the TS packages encapsulated in one UDP package. The valid range
goes from 1 to 7.
Time To Live:• set the number of the routers over which the TS over IP can be transmitted. The valid range
goes from 1 to 5.
Type of Service:• select the type of service. There are: Normal, Min Monetary Cost, Max Reliability, Max
Throughput or Min Delay optional.
Source: • select the source of the transport stream over IP streaming output.
There are 5 type of source optional:
ASI1 Input
ASI2 Input
CI De-encrypted
TUNER
Mux TS
Note: the Mux TS is showed only when the Mux function block is enabled and turned on. Refer to section ‘Mux’
and section ‘Optional Function’ for how to set the Mux function block.
After the operation, the selected transport stream will be delivered to the TS / IP function block for further
operation.
Mode:
• select the mode of IP stream, you can select DVB or IPTV.
DVB mode: • the transport stream which comes from the ‘source’ selected in previous step will be packed
into IP Stream directly. Therefore the IP stream carries all programs and be delivered to the specied
Multicast or Unicast IP address.
IPTV mode:• the transport stream which comes from the ‘source’ selected in previous step will be de-
Muxed to several single programs, and each program is packed into one IP stream. Therefore each IP
stream carries only one program and be delivered to the specied Multicast or Unicast IP address. You can
congure maximum 6 IPTV channels.
Multicast Setup:• use <ENTER> key to enter sub-menu. The sub-menu is different according to different
‘mode’ selected in previous step.
DVB mode
Multicast IP:
• Enter the IP address of the IP stream for the transport stream over IP output. You can
congure the IP stream output mode in Multicast or Unicast.
Multicast could be established by setting Multicast IP address in the range of 239.255.255.255 to
224.0.0.0.
Unicast could be established with the same settings of Multicast, the only differences are the Multicast IP
address, and should NOT be in the range of 224.0.0.0 to 239.255.255.255, which is for Multicast. Although
the display is ‘Multicast IP’ on the rst row, the stream itself is Unicast. The IP address of receiver device
(maybe PC with VLC) needed to be set to as the unicast address on IDLV-5000P, please don’t use DHCP
to get a dynamic IP address for receiver device.
Multicast UDP Port:• Enter the UDP port number of the TS over IP stream output.