Operation Manual

Decoder version:• show Decoder version

FPGA version:

• show FPGA version

TS/IP IN (or OUT) NIOS:• it’s changed when TS/IP board is set to “IP Out” or “IP IN”.

TS/IP IN (or OUT) FPGA: • it’s changed when TS/IP board is set to “IP Out” or “IP IN”.

5.3.5 Factory Setting

All the user congurable parameters will be set to the factory default settings, including IP address and the unit

name.

5.3.6 Optional Function

There are two submenus:

1. External Board Type: Press <ENTER>-key to active the menu, use <UP> <DOWN> keys to congure the

TS/IP functional block as ‘IP In’ or ‘IP Out’ or ‘No Exist’, and the option is exclusive. Press <ENTER> key to

conrm or to scrap by pressing <EXIT> key.

After the operation, you need reboot the unit to valid the conguration.

IP In: the TS/IP port is congured as input, you can feed transport stream over IP into the unit.

The menu ‘Ethernet’ will be showed under the inputs menu.

IP Out: the TS/IP port is congured as output, you can set the transport stream over IP output to the IP network.

The menu ‘Ethernet’ will be showed under the outputs menu.

No Exist: the TS/IP port is invalid. Therefore the menu ‘Ethernet’ will not be showed anywhere.

2. Mux Function: Press <ENTER> key to active the menu, use <UP> <DOWN> keys to congure the Mux

functional block as ‘Enable’ or or ‘Disable’. Press <ENTER> key to conrm or to scrap by pressing <EXIT> key.

5.3.7 Machine Type

This setting is reserved for factory-setting, and you are not allowed to access this menu.

6. FAQ

1. Why is there nothing in the LCD?

Answer: Please check whether the power supply is connected well rst. If not, insert it well and turn on the

device. If there is still nothing displayed on the LCD, then the unit may be damaged, please contact the agent for

technical support.

2. Why can the DVB-S2 signal not be locked?

Answer: Please ensure whether the input cable in connected well rst. If not, insert it well. If it is connected well,

please check whether all the necessary parameters are set properly. If not, please set the parameters properly.

If the signal still cannot be locked, please check whether the quality of the signal is out of the threshold of the

Tuner. If not, then the device might be damaged, please contact the agent for support.

3. Why can the ASI not be locked?

Answer: Please make sure the BNC cable is connected well and there are programs transmitted to the unit via

the BNC cable.