Operation Manual
En
3
Thank you for purchasing the IDLV-5000P series.
This User Manual is written for operators/users of the IDLV-5000P Multi-Format Professional HDTV Processor
to assist in installation and operation. Please read this user manual carefully before installation and use of the
device
FOR YOUR SAFETY
This equipment is provided with a protective earthing ground incorporated in the power cord. The main plug shall
only be inserted in a socket outlet provided with a protective earth contact. Any interruption of the protective
conductor, inside or outside the device, is likely to make the device dangerous.
Do not remove the covers of this equipment. Hazardous voltages are present within this equipment and may be
exposed if the covers are removed. Only Inverto trained and approved service engineers are permitted to service
this equipment.
No operator serviceable parts inside. Refer servicing to Inverto trained and approved service engineers.
For the correct and safe use of the device, it is essential that both operating and servicing personnel follow
generally accepted safety procedures in addition to the safety precautions specied in this manual.
Whenever it is likely that safety protection is impaired, the device must be made in-operative and secured
against unintended operation. The appropriate servicing authority must be informed. For example, safety is likely
to be impaired if the device fails to perform the intended measurements or shows visible damage.
WARNINGS
The mounting environment should be relatively dust free, free of excessive vibration and the ambient
•
temperature between 0C° to 40C°. Relative humidity of 20% to 80% (non-condensed) is recommended.
Avoid direct contact with water.•
Never place the equipment in direct sunlight.•
The outside of the equipment may be cleaned using a lightly dampened cloth. Do not use any cleaning •
liquids containing alcohol, methylated spirit or ammonia etc.
For continued protection against re hazard, replace line fused only with same type.•
Air intake for cooling is achieved via holes at the side of the device and the fans inside. The air ow should •
not be obstructed. Therefore, the device has to be placed on a at surface, leaving some space at the
sides of the device.
When in operation, the internal temperature should not exceed the limit of 70C
• °.
1. Before Use the Device