Operation Manual

En
7
5.1 INPUTS MENU
There are four options: Status, DVB-S2, RSSI and Ethernet (optional):
5.1.1 Status Menu
It contains four options, ASI1, ASI2, TUNER and IP IN, to show the status of signal input:
ASI1:
• When signal from ASI1 input port is locked, it will display package format and code rate; if signal is
not locked, it will show Unlock.
ASI2:• When signal from ASI2 input port is locked, it will display package format and code rate; if signal is
not locked, it will show Unlock.
TUNER:• When signal from tuner input port is locked, it will display package format and code rate; if signal
is not locked, it will show Unlock.
IP IN: • When signal from IP input port is locked, it will display package format and code rate; if signal is not
locked, it will show Unlock.
Note: this option only appears when set the External Function as “IP IN”. Please refer to section ‘Optional
Function’ for setting method.
5.1.2 DVB-S2 Menu
There are 6 options to set DVB-S2 parameters. After signal is locked, the TUNER LOCK indicator on front panel
will turn green.
LNB Frequency:
• Input LNB frequency
Satellite Frequency:• Input downstream frequency of satellite
Symbol Rate:• Input symbol rate of satellite
LNB Voltage:• select the correct LNB voltage output of the F-connector: Off, 13 V, 18 V. <A>
LNB 22KHz: • activate the LNB 22 kHz control signal to the LNB: On or Off. <B>
DISQEC: • Can select OFF/Port A/Port B/Port C/Port D
Note: please contact the local satellite operator for the satellite frequency and symbol rate.
<A> Normally, 13V switches the LNB to receive Vertical/Left hand polarization while 18V receive Horizontal/Right
hand.
<B> Normally, 22KHz control signal switches the LNB to receive high band if any.
5.1.3 RSSI
There are two options to show the quality of receiving DVB-S2 signal.
5.1.4 Ethernet Menu
Note: The Ethernet menu is showed only if the IP streaming in/out board is installed and the TS/IP streaming
board is set to “IP IN”. Refer to section ‘Optional Function’.
The Ethernet connector is for receiving transport stream over IP. The Ethernet connector has user-congurable
IP address, network mask and default gateway. These must be set to appropriate values for the network over
which the transport stream over IP is received.
Stream IP Addr:
• Enter the IP address for streaming IP input of the unit.
Stream Netmask:• Enter the network sub mask for the subnet to which the unit is connected for IP
streaming trafc.
Stream Gateway:• Set the gateway for the network to which the unit is connected for IP streaming trafc.
Stream Mac Address:• factory-set MAC addresses are guaranteed to be unique. Therefore you cannot
congure the address.
Inputs
Status
DVB-S2
RSSI
Ethernet