Operation Manual

8
Multicast IP Addr:• Enter the IP address of the multicast stream for the transport stream over IP.
Multicase UDP Port:
• Enter the UDP port number of the TS over IP stream.
Protocol: • select the protocol for multicast: UDP or RTP.
Output Smoothing:• set the quality of TS which comes from the TS/IP input.
Auto:• the bit rate is variable.
Disable:• the unit let the TS pass by.
Fixed Rate:• the bit rate is xed.
TS Bit Rate:• set the bit rate of the TS comes from the TS/IP input. The setting is only valid when the output
smoothing is congured as Fixed Rate.
5.2 OUTPUTS MENU
Under Outputs Menu, you can monitor and congure the parameters of the CI, AV decoder, ASI out, ASI2/SDI
out, Mux (A), BISS, SDI out and TS over IP output (B).
Note:
(A) The Mux menu is showed only if the functional block is enabled. Refer to section ‘Optional Function’.
(B) The Ethernet menu is showed only if the IP streaming in/out board is installed and the TS/IP streaming board
is set to “IP Out”. Refer to section ‘Optional Function’.
5.2.1 BISS Menu
It includes Biss Mode, Biss 1 Setup and Biss E Setup
Biss Mode: Set Biss mode, can select OFF, Biss E or Biss 1
Biss 1 Setup: set Biss 1, password is required
Biss E Setup: set Biss E, ID number and password are required
5.2.2 CI Menu
There are two PCMCIA slots for inserting CAM for de-encrypting program from the input signal.
Before setting CI, ensure the signal from ASI input is locked or the Tuner locks on the correct Transponder (this
depends on in which signal the encrypted program carried). The ‘Tuner Lock’ LED will ‘on’ in green.
There are 3 submenus: ‘CI Source’, ‘Setup’ and ‘CAM name’ which allow you to set or select the parameters of
the CI.
1. CI Source: press the <ENTER> key, then use <UP> or <DOWN > key select Tuner or ASI1 input or ASI2
input or TS/IP input (only when the TS/IP is set “IP In”, refer section 5.2.7 for details) to set the signal source of
descrambling, press <ENTER> key to save or press <EXIT> key to scrap.
2. Setup: under this sub menu, you can see all program names from the source of CI that was set in ‘CI Source’
previously. All free programs are marked with ‘Free’ in the rst row.
To select which program to be de-encrypted, press the <UP> or <DOWN>key to roll up and down the program
names and press <ENTER> key to change the status of the corresponding program (only encrypted program
could be selected). Three different statuses could be set:
Slot 1 (de-encrypted with upper CAM inserted)
Slot 2 (de-encrypted with lower CAM inserted)
Bypass (no de-encryption).
The status will be shown in the rst row on the LCD display. Conrm this setup when leaving this sub menu,
press <ENTER>key to save or press <EXIT>-key to scrap.
The de-encrypted program could be delivered to other functional blocks, like A/V decoder, ASI1, ASI2, SDI, Mux
and TS/IP output (refer to section 5.2.3~5.2.8 for more).
3. CAM name: under this sub menu, you can see the names of CAM modules.
Outputs
CI
Decoder ASI1 ASI2 SDI Ethernet MuxBISS