Instructions / Assembly

Shingle
For more information on the Solid Vinyl Gutter Cover other innovative products
from InvisaFlow please visit www.invisaow.com
As you install each section simply
overlap the end with the previous
section to prevent gaps.
At the end of the gutter, cut the last gutter cover an extra 2 inches longer than the end
of the gutter. Cut a notch on the back edge of the gutter lter (A) and on the front edge
(B). Bend the end section down to create the end cap.
5
Starting at one end of the gutter, install
the gutter lter by slightly lifting the
shingles and sliding the gutter cover
under the shingle. If the starter row of
shingles are fastened to the roof deck
slide the guard between the layers.
(Note: Check your local building codes
for any special installation requirements)
Pull the front edge forward to engage with
the lip of the gutter.
6
For outside corners (A) or inside
corners (B), mitre cut both adjoining
sections. Notch the front edge of one
section to create an overlap.
Outside
Corner
Inside
Corner
(A)
(B)
Notched for
over lapping
End Cap
(A)
(B)
Shingle