User Manual

Operation

Using the Radio

Selecting a radio station:

1. Press the Radio button to select FM1, FM2, or AM.

2. Press either of the Tune/Track buttons to select a radio station. To “seek” (jump to the next available

station), hold either button down for a few seconds until it starts to seek a station.

Saving a radio station as a preset:

1. Press the Radio button to select FM1, FM2, or AM.

2. Press either of the Tune/Track buttons to select a radio station.

3. Press and hold a numeric preset button to assign the current station to that preset number. The

display will show “SAV” to show the station has been saved.

Recalling a saved radio station preset:

1. Press the Radio button to select FM1, FM2, or AM.

2. To use an added preset, press a preset number once lightly to go to the stored radio station.

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.

2. Power on Party Boom. Press and release the Bluetooth button to start pairing. The Bluetooth

icon on the display will start to blink when attempting to pair. If you have previously connected to

another Bluetooth device, Party Boom will reconnect. To disconnect pairing if the Bluetooth icon

is lit solid, press and release the Bluetooth button.

3. Navigate to your Bluetooth device’s setup screen, find “Party Boom” and connect. The

Bluetooth icon on the display will be lit solid when paired.

Note: If your Bluetooth device prompts for a pairing code, enter “0000”.

4. To disconnect pairing while the Bluetooth icon is lit solid, press and release the Bluetooth

button.

5. To connect to another Bluetooth device, repeat step 3.

Pairing a Bluetooth Device Using NFC

NFC (near-field communication) allows data exchange from devices, such as pairing, by gently

bumping them together. Check in your device’s manual to see if this feature is supported.

To use NFC to pair with Party Boom:

1. In order to use NFC, your device must be turned on and unlocked.

2. Enter your device’s Settings menu and check that NFC is turned On (one-time step).

3. Power on Party Boom.

4. Press and release the Bluetooth button on Party Boom and the Bluetooth icon will flash (only

needed for the first time when NFC pairing with the device).

5. Touch and briefly hold your device to the NFC logo.

6. Follow the pairing instructions that appear on your phone. If a passcode is required, enter

“0000”.

To unpair, gently bump your device against the NFC logo located on Party Boom’s top panel.