Quick Start Guide

6
Recording from Bluetooth to Tape:
1. Set the Function switch to BT/USB/SD.
2. Turn on your Bluetooth device. See the section Pairing a Bluetooth Device for setup details.
3. Play your Bluetooth track.
4. Press the cassette Record button to record to tape.
Recording from the Internal Microphone to a USB Flash Drive or SD Card:
1. Insert a USB flash drive or SD card into the unit.
2. Set the Function switch to USB.
3. Press and hold the Record/Play/Pause button to start recording and speak into the internal
microphone.
4. Press and hold the Record/Play/Pause button to stop recording. The recorded audio will then
playback automatically.
Recording from the Radio to a USB Flash Drive or SD Card:
1. Insert the USB flash drive into the USB port or insert an SD card into the SD card slot.
Note: Only use either a USB flash drive or an SD card at a time, but not both when recording.
The unit may not record properly if both a USB and an SD card is plugged in at the same time.
2. Set the Function switch to Radio.
3. Set the Band switch to desired frequency band (AM, FM, SW1, or SW2).
4. Adjust the Tune dial to select a radio station.
5. Extend and adjust the antenna for best reception.
6. To start recording, press and hold the Record/Play/Pause button.
7. To stop recording, press and hold the Record/Play/Pause button.
Recording from Tape to a USB Flash Drive or SD Card:
1. Press the Stop/Eject button to open the cassette holder.
2. Insert a tape and close the cassette holder.
3. Insert the USB flash drive into the USB port or insert an SD card into the SD card slot.
Note: Only use either a USB flash drive or an SD card at a time, but not both when recording.
The unit may not record properly if both a USB and an SD card is plugged in at the same time.
4. Set the Function switch to Tape and press Play to playback the tape.
5. To start recording, press and hold the Record/Play/Pause button. The LED will flash blue.
6. To stop recording, press and hold the Record/Play/Pause button.