- Yamaha AV Receiver AV Amplifier Owner's Manual RX-V750 DSP-AX750SE

71
English
REMOTE CONTROL FEATURES
ADVANCED
OPERATION
You can clear all changes made in each function set, such
as learned functions, renamed source names and setup
manufacturer codes.
1 Press CLEAR by using a ballpoint pen or
similar object.
y
Complete each of the following steps in 30 seconds. Other
wise, the learning mode will be automatically canceled. In
this case, press CLEAR again.
2 Press u / d to select the clear mode.
L:DVD
(L: name of a component)
Clears all learned functions in the respective
component control area. Press an input selector
button to select the component.
L:AMP Clears all learned functions for this unit’s control
area.
L:ALL Clears all learned functions.
RNAME Clears all renamed source names.
FCTRY Clears all remote functions and returns the remote
to the factory settings.
3 Press and hold CLEAR again for about 3
seconds.
“C:OK” appears in the display window.
“C:NG” appears in the display window if the operation is
unsuccessful. In this case, start over from step 2.
4 Press CLEAR to exit from the clearing mode.
Once you have cleared a learned function for a
button, the button reverts to the factory preset setting.
“ERROR” appears in the display window under the following
circumstances:
– When a button other than the cursor is pressed.
– When more than one button is pressed at the same time.
Clearing function sets
Note
CLEAR
CLEAR
Note
CLEAR
01EN_00_RXV750_GB.book Page 71 Friday, March 5, 2004 11:40 AM