Installation Guide

PAGE 1

Dual Mount Stainless Steel Sink

Installation Instructions

Before You Start

• IPT Sink Company recommends that all undermount sinks be installed by an experienced, professional installer.

• IMPORTANT: It is recommended that you discuss with your installer and agree that the finished appearance is the

desired effect. IPT Sink Company is not responsible for improper sink or countertop installations.

• IMPORTANT: The cabinet must be installed, secured, plumb, and level. Failure of this step can lead to product damage.

• IPT Sink Company undermount sinks should only be fastened to a solid surface countertop (i.e. granite, Corian® or

Silestone®).

• IPT Sink Company is not responsible for sink or countertop if damaged during installation. Be sure to inspect the sink

for damage prior to beginning installation.

• Metal edges may be sharp – use caution when handling.

• Follow all local plumbing and building codes.

Recommended Tools & Materials (Not Included)

 Tape Measure

 Safety Glasses

 Painter’s Tape

 Level

 Framing Square

 Pencil (not permanent marker)

 Shims or Cabinet Fillers

 Denatured Alcohol

 Clamps

 Construction Adhesive

 Silicone Sealant

 Screws (recommended by countertop manufacturer)

R50 Dual Mount Double

Bowl Kitchen Sink

R22 Dual Mount Double

Bowl Kitchen Sink

R15 Dual Mount Double

Bowl Kitchen Sink

PAGE 1
Dual Mount Stainless Steel Sink Installation Instructions R15 Dual Mount Double Bowl Kitchen Sink R22 Dual Mount Double Bowl Kitchen Sink R50 Dual Mount Double Bowl Kitchen Sink Before You Start • IPT Sink Company recommends that all undermount sinks be installed by an experienced, professional installer. • IMPORTANT: It is recommended that you discuss with your installer and agree that the finished appearance is the desired effect.
PAGE 2
Dual Mount Stainless Steel Sink Top Mount Installation Instructions 1 2 PREPARING THE COUNTERTOP Position the sink (A) upside down on the countertop. Trace completely around the edge of the sink (A). Draw a line 5/16” inside of the outline of the sink. CUTTING THE COUNTER WARNING: Always wear safety goggles and gloves when using power tools to prevent personal injury. Drill a pilot hole in all four corners of the inside line. Use a saber saw or jig saw to cut on the inside line.
PAGE 3
Dual Mount Stainless Steel Sink Undermount Installation Instructions 1. Position the template (provided with your sink) front to rear so the sink 1: Prep Countertop OUTLINE FOR UNDERMOUNT SINK CUTOUT will not interfere with the cabinet; secure with tape. 2. Trace the template and remove. Dry fit the sink to verify the measurements. 3. Following the countertop manufacturer’s instructions, carefully cut the countertop on the inside of the traced line. MOUNTING BRACKET FASTENER 4.