Operation Manual

How to Have Strong Stations Available Only?
 By default, FM scans stop at any available station. This may result in a poor signal-to-
noise ratio (hiss) from weak stations.
 To change the scan settings to stop only at stations with good signal strength, please
follow 2 steps:
1. Press MENU, while cursor point to < Scan setting >, press the SELECT knob to confirm.
 Note: there are only two options available - ‘Strong stations only’ and ‘All stations’.
2. Turn the SELECT knob to ‘Strong stations only’, press this knob to confirm.
How to Set Audio to ‘Forced Mono’?
 By default, all stereo stations are reproduced in stereo. For weak stations, this may result
in a poor signal-to-noise ratio (hiss).
 To play weak stations in mono, please follow below 2 steps:
1. Press MENU, and then turn the SELECT knob to < Audio setting >, press this knob to
confirm.
 Note: there are two options available - ‘Stereo allowed’ and ‘Forced mono’.
2. Turn the SELECT knob to ‘Forced mono’, and then press this knob to confirm.