Use and Care Manual

EN
Roomba Combo j7 Owner’s Guide 7
Cleaning the Multi-Surface Brushes Cleaning the Front Caster Wheel
1 1
3
2
4
3
2
4
Pinch the brush frame release tab, lift the
tab, and remove any obstructions.
Pull firmly on the front wheel module to
remove it from the robot.
Remove any debris from inside the
wheel cavity.
Pull firmly on the wheel to remove it from its
housing (see illustration below).
Reinstall all parts when finished.
Make sure the wheel clicks back into place.
Remove any hair or debris from the square
and hexagonal pegs on the opposite side
of the brushes.
Remove the brushes from the robot.
Remove the brush caps from the ends of
the brushes. Remove any hair or debris
that has collected beneath the caps.
Reinstall the brush caps.
Reinstall the brushes in the robot. Match
the shape of the brush pegs with the
shape of the brush icons in the cleaning
head module.
Important: A front wheel clogged with
hair and debris could result in damage to
your floor. If the wheel is not spinning freely
after you have cleaned it, please contact
Customer Care.
Wheel
Axle
Housing