Use and Care Manual

ManualsBrandsiRobot ManualsAppliancesRoomba Combo J7+ Self Emptying Robot Vacuum & Mop with Smart Mapping, Identifies & Avoids Obstacles

10 For more information, visit global.irobot.com

FCC Supplier’s Declaration of Conformity

iRobot Corporation Roomba Model: RCA-Y1

FCC ID: UFE-RCAY1

Contains FCC ID: UFE-AXGY1 and contains IC: 6652A-AXGY1

This device complies with part 15 of the FCC Rules and ICES-003.

Operation is subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

This device complies with Industry Canada license-exempt RSS standard(s).

Operation is subject to the following two conditions: 1) This device may not

cause interference, and 2) this device must accept any interference, including

interference that may cause undesired operation of the device.

• Changes or modifications not expressly approved by iRobot Corporation

could void the user’s authority to operate the equipment.

• This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules as well as ICES-

003 Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference to radio

communication will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• Under Industry Canada regulations, this radio transmitter may only operate

using an antenna of a type and maximum (or lesser) gain approved for

the transmitter by Industry Canada. To reduce potential radio interference

to other users, the antenna type and its gain should be so chosen that

the equivalent isotropically radiated power (e.i.r.p.) is not more than the

necessary for successful communication.

• FCC Radiation Exposure Statement: This product complies with FCC

§2.1091(b) for mobile device RF exposure limits, set forth for an uncontrolled

environment and is safe for the intended operation as described in this

manual. Per FCC requirements, maintain a distance of more than 8 inches

(20 cm) between any person and the host device (Roomba Combo robot).

• ISED Radiation Exposure Statement: This product complies with the Canadian

Standard RSS-102 for mobile device RF exposure limits, set forth for an

uncontrolled environment and is safe for the intended operation as described

in this manual. Per ISED requirements, maintain a distance of more than 8

inches (20 cm) between any person and the robot.

iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA.

https://global.irobot.com

For battery recycling go to call2recycle.org;

or call 1-800-822-8837

Regulatory Information