Use and Care Manual

Roomba Combo j7 Owner’s Guide 3

Mopping

• Your robot is able both vacuum and mop at the same time. To start a

vacuum and mop cleaning job from your robot, fill the tank, attach a

mopping pad, and press the clean button.

• When your robot encounters carpet during it’s

cleaning job, it will lift and tuck the mopping

pad away.

• After completing your mopping and vacuum

cleaning job, make sure to empty the water

tank and replace the mopping pad.

• Your robot will automatically explore and clean your home in neat rows,

avoiding obstacles using its front-facing camera. It will return to the charging

station at the end of a cleaning job and whenever it needs to recharge.

• To end a job and send the robot back to its charging station, hold the clean

button down for between 2-5 seconds. A blue light ring pattern will indicate

that the robot is seeking the charging station.

• When your robot detects an especially dirty area, it will engage Dirt Detect™

mode, moving in a forward/backward motion to clean the area more

thoroughly. The light ring indicator will flash blue.

Vacuuming

• To start a vacuum-only cleaning job from your robot, empty the tank or

detach the mopping pad before pressing the clean button.

Just press the clean button

Tap to Start / Pause / Resume

Hold for 2-5 seconds to end a job

Your robot is able to recognize and avoid

objects. However, it is still recommended

to remove excess clutter before cleaning.

When your robot senses that its bin needs

to be emptied, the light ring indicator

will illuminate in a red sweeping motion

toward the rear..

Cleaning

WARNING: To prevent damaging your robot, do not manually stow the

mopping pad plate onto the pad shelf.

Press bin release button to

remove bin.

Attach mopping pad.

Fill tank with water and

compatible cleaning solution.

Place bin back in the robot.