User Guide

5 For more information, visit global.irobot.com
Roomba
®
i Series Owner’s Guide 6
ENEN
Care and Maintenance Instructions
To keep your robot running at peak performance, perform the
procedures on the following pages.
There are additional instructional videos in the iRobot HOME App.
If you notice the robot picking up less debris from your floor, empty
the bin, clean the filter and clean the brushes.
Part Care Frequency Replacement
Frequency*
Bin Wash bin as needed
Filter Clean once a week (twice
a week if you have a pet).
Do not wash.
Every 2 months
Full Bin Sensor Clean every 2 weeks
Front Caster
Wheel
Clean every 2 weeks Every 12 months
Edge-Sweeping
Brush and
Multi-Surface
Brushes
Clean once a month
(twice a month if you
have a pet)
Every 12 months
Sensors and
Charging
Contacts
Clean once a month
Care and Maintenance
Note: iRobot manufactures various replacement parts and assemblies. If
you think you need a replacement part, please contact iRobot Customer
Care for more information.
* Replacement frequency may vary. Parts should be replaced if visible
wear appears.
Emptying the Bin
Open bin door to empty bin.
Press bin release
button to remove bin.
1
2
Place bin back in the robot.
3
Cleaning the Filter
Remove the bin. Remove the
filter by grasping both ends
and pulling out.
Remove debris by
tapping the filter against
your trash container.
Reinsert filter with ridged
grips facing out. Place bin
back in the robot.
1
2
3
Important: The robot will not run
if the filter is not installed correctly.
Replace the filter every two months.
6 For more information, visit global.irobot.com
Washing the Bin
Cleaning the Full Bin Sensors
Wipe the inner sensors with a
clean, dry cloth
Make sure bin is completely dry. Reinsert
filter and place bin back in the robot.
Wipe the bin door with a clean, dry cloth.
2
3
3
Important: Do not wash the filter.
Remove the filter before washing the bin.
Release the bin, remove the filter,
and open the bin door.
Remove and empty the bin.
1
1
Note: Bin is not dishwasher safe.
Use a coin or small screwdriver
to remove the screw holding the
Edge-Sweeping Brush in place.
Pull to remove the Edge-Sweeping
Brush. Remove any hair or debris,
then reinstall the brush.
Cleaning the Edge-Sweeping Brush
1
2
Rinse the bin using warm water.
2
Closed Door
Opened Door