Operation Manual

iRobot Scooba 200 Series Owner’s Manual
14
Numberof
beeps/blinks
afteruh-oh
Likelycause What to do
0 (error LED
on solid)
Fill tank is empty Fill tank with water and cleaning solution and press clean.
1 Scooba is on cliff
Cliff sensors are dirty
Cliff Sensor malfunction
MoveScoobatoclearareaawayfromcliffand press clean.
Clean cliff sensors with a cotton swab and press clean.
CliffsensorsarelocatedinthebumperandareaccessedbyturningScoobaover.
Contact iRobot customer care.
2 Scooba is stuck Movetoclearareaandpressclean.
Clean cliff sensors and press clean.
MoveoutofVirtualWallbeamand press clean.
3 Bumper problem Tapthebumpertoensurethatitmovesinandout.Visuallyinspectthe
bumper edges for debris and press clean.
4 Left or Right Wheel malfunction Inspect and clean Scooba’s wheels and press clean.
5 Scooba is in a pool of water
andvacuumtubesarelocked
Scooba’svacuumtubesare
lledwithdebris
MoveScoobaoutofpooledwaterandpressclean.
(Note: Scooba is not intended for cleaning up pooled spills)
Removebottomplate.Clearanydebrisfromvacuumtubes.
Replace bottom plate, set robot in clear area and press clean.
(Note:BesuretosweeptheoorbeforeusingScooba.)
6 Pump malfunction Contact iRobot customer care.
7 Vacuum malfunction Contact iRobot customer care.
Troubleshooting
Scoobawilltellyouifsomethingiswrongwithatwo-tone“uh-oh”soundandaseriesofbeepsandlight
blinks. CountlightblinksorbeepsandrefertothechartbelowtoidentifyandresolveScooba’sproblem.
To repeaterrorblinksandbeeps,tapScooba’sbumper.Iftheproblempersists,visitwww.irobot.
com/support for more information.
Charger Light Likelycause What to do
Charger is plugged in and
connected to robot, but light is off
Charging
error
Disconnect charger from robot; unplug charger from outlet; wait 5 seconds;
plug charger in to outlet; connect charger to robot
Charger is plugged in and
connected to robot, but light is off
No power
at outlet
Conrmpowerispresentatoutletbyplugginginalamporanother
electricaldevice.Ifstillnopower,useanotherelectricaloutlet.