Instructions / Assembly

8. Now, place the slab(s) onto secure saw horses or other support to install the sweeps. Make sure to protect the
surface of the door by putting a moving blanket or carpet on top of whatever the doors will be resting on. Now that the
doors are resting securely on your ‘work station’, it is time to install the sweeps on the bottom of the slabs.
9. Install the sweeps onto the bottom of the slab in the method shown in picture 5, 6 & 7:
How to Install Sweeps
1. SWEEPS are packaged with your door slab(s). Picture 5
2. You may need to trim them to fit. Picture 6
3. Remember to drill a hole in the sweep for the
flush bolt of the inactive double door.
4. Tap sweep into grooves of slab with a hammer. It may be
necessary to use a shim to help seat the fins of the sweep
into the groves. Picture 7
Picture 5
Picture 6 Picture 7
10. You are ready to hang the slabs on the hinges. Make sure to install the washers on the hinge pins before hanging
slabs. We recommend removing the glass from the slab to make the door lighter, and easier to handle when re-hanging
the doors (picture 8). Placing the slab on the hinges is best done with two installers. Pay close attention to where you
handle the door, especially if you are holding the door by its scroll work. The scroll work could become bent or damaged
if pressure is applied in the wrong fashion.
Picture 8
2