Santorini II 10-ft Square Cantilever Umbrella with Sunbrella® Fabric Please Do N ot Hesitate to Contact Our Consumer H otline at 800-759-0 9 7 7 with Any Qu estions That May Arise During Assembly or Use of This P roduct! NU6045B • NU6050B • NU6055B • NU6070B • NU6080B NU6170B • NU6175B • NU6180B • NU6185B • NU6190B Ver. 0719 www.bluewaveproducts.
PACKAGE CONTENTS A – (1) Main Umbrella* B – (1) Plastic Water Fillable Stand A F (incl.
ASSEMBLY INSTRUCTIONS Carefully check all packaging materials before discarding. Do not assemble if there are missing pieces. Step 1 Put the stand on a level ground where you intend to locate your umbrella. Open the cap on the top of the stand & fill the stand with water. Then tighten the cap. In case you want to move the stand, Step 2 Put the Base pole ( part C ) on the top of the Plastic Water Fillable Stand .
Step 3 Fix the Base Pole ( part C ) on the top of the Plastic Water Fillable Stand ( part B ) with bolts F & washers G use the Allen Wrench (E) Bottom crank hole C E F G B Step 4 Put the Swivel Cover ( part D ) around the Base Pole ( part C ) . C Bottom crank hole Locking hole for threaded knob side A +/- 1.4” B D Side B +/-1.7” side B Important Notice : Pay attention to the size of the middle hole in the Swivel Cover (part D). Side A / Front Side : +/- 1.4" , Side B / Rear Side : +/- 1.7" .
Step 5 Put the Main Umbella (Part A ) outside the Base Pole ( Part C ) Important Notice : When you put the Main Umbrella outside the Base Pole, make sure the locking holes are on the same side .
Step 6 Fix the Threaded Knob ( Part H ) into the locking hole.
Step 7 There are 3 Crank Holes on your umbrella. Top crank hole for canopy tilting, Bottom crank hole for 360 degree rotation. Middle crank hole for umbrella opening and closing.
Step 8 Squeezing the trigger before attempting to raise the crank house. Fix the Crank Handle (I) into the middle crank hole and turn clockwise to extend the umbrella fully . A 1 I 2 I B Caution: Please pull and loose the umbrella ribs by hand before attempting to open the umbrella by crank.
Step 9
Step 10 Fix the Crank Handle (I) into the top crank hole to tilt your umbrella canopy.
Step 11 I Fix the Crank Handle (I) into the bottom crank hole to rotate your umbrella in 360 degrees.
Step 12 Squeezing the trigger before attempting to lower the crank house. Turn the Crank handle counter-clockwise to close the umbrella. A First Step I Second Step I B Step 13 When not in use, place Umbrella Cover (part J) over the umbrella .
3 Year Limited Warranty Guarantee: Blue Wave Island Umbrellas being used in residential applications only are guaranteed to be free from defects in original material and workmanship. Frames and Accessories Limited Warranty: 3 Years (1 Year on Santiago cantilever frame) Includes: original material or workmanship appears during the warranty period on any Blue Wave umbrella product; Blue Wave, at its option, will repair or replace the product without charge.
FABRIC WARRANTY WHO THIS WARRANTY PROTECTS This warranty protects the original purchaser of Sunbrella fabric. WHAT THIS WARRANTY PROTECTS AGAINST This warranty protects against Sunbrella fabric becoming unserviceable due to color or strength loss from normal usage and exposure conditions, including sunlight, mildew and atmospheric chemicals. WHAT THIS WARRANTY COVERS This warranty covers Sunbrella fabric only.
Parasol suspendu carré Santorini II de 10 pieds en toile Sunbrella® Veuillez ne p as hésiter à communique r avec notre service d'assistance téléphonique aux consommate urs au 800-7 5 9-0977 en cas de qu estions pouv ant survenir lors du montage o u de l'utilisation d e ce produit ! Ver. 0719 www.bluewaveproducts.
CONTENU DU PAQUET A - (1) Parasol principal* A B - (1) Support en plastique remplissable à l'eau (inclus dans un carton séparé comme NU6000JL) C - (1) poteau de support, NUP4117 B D - (1) Couvercle pivotant, NUP4118 E - (1) Clé Allen, NUP4119 F - (4) Boulon en acier inoxydable, NUP4120 G - (4) Rondelle, NUP4121 C H - (1) Bouton fileté, NUP4122 I - (1) Manivelle, NUP4123 J - (1) Housse de parasol, NUP4124 * Pour le remplacement du parasol D principal, veuillez indiquer le numéro d'article de votre parasol.
INSTRUCTIONS DE MONTAGE Vérifiez soigneusement tous les matériaux d'emballage avant de les jeter. Ne pas assembler s'il manque des pièces. Étape 1 Posez le support sur une surface plane à l'endroit où vous avez l'intention d'installer votre parasol. Ouvrez le bouchon sur le dessus du support et remplissez-le d'eau. Serrez ensuite le bouchon. Le support est assez lourd lorsqu'il est rempli d'eau (200lbs). Si vous voulez déplacer le support, ouvrez le bouchon latéral et videz l'eau préalablement.
Étape 3 Fixez le poteau de base (partie C) sur le dessus du support en plastique remplissable à l'eau (partie B) avec boulons F & rondelles G utiliser la clé Allen (E) Trou de manivelle inférieur C E F G B Étape 4 Placez la protection pivotante (partie D) autour du poteau de support (partie C). C Trou de verrouillage pour bouton fileté Trou de manivelle inférieur side A +/- 1.4” B D Side B +/-1.
Étape 5 Placer le parasol principal (partie A) à l'extérieur du mât de base (partie C) Avis important : Lorsque vous placez le parasol principal à l'extérieur du mât de base, Vous assurez que les trous de verrouillage sont du même côté.
Étape 6 Fixez le bouton fileté (partie H) dans le trou de verrouillage.
Étape 7 Il y a 3 trous de manivelle sur votre parasol. Trou de manivelle supérieur pour le basculement de l'auvent, Trou de manivelle inférieur pour une rotation de 360 degrés. Trou de manivelle central pour l'ouverture et la fermeture du parasol.
Étape 8 Appuyer sur la gâchette avant d'essayer de soulever le carter de manivelle. Fixer la manivelle (I) dans le trou de manivelle central et tournez dans le sens des aiguilles d'une montre pour déployer complètement le parasol. A 1 I 2 I B Attention : S'il vous plaît, tirez et détachez les baleines du parasol à la main avant de tenter de l’ouvrir le parasol avec la manivelle.
Étape 9 Étape 9 Il y’a 6 trous de positionnement sur le poteau principal pour fixer le parasol à différents angles.
Étape 10 I Fixez la manivelle (I) dans le trou supérieur de la manivelle pour incliner votre parasol.
Étape 11 Fixez la manivelle (I) dans le trou inférieur de la manivelle pour faire pivoter votre parasol de 360 degrés.
Étape 12 Appuyer sur la gâchette avant de tenter d'abaisser le carter de manivelle. Tournez la manivelle dans le sens inverse des aiguilles d'une montre pour fermer le parasol. A Première étape I Deuxième étape I B Étape 13 Lorsqu'il n'est pas utilisé, placez la housse de parasol (partie J) sur le parasol.
Garantie : Garantie limitée de trois ans Seulement les parasols Island de Blue Wave utilisés dans les applications résidentielles sont garantis contre tout défaut de matériaux ou de fabrication. Garantie limitée de trois ans sur l’armature et les accessoires (1 an sur la base d’acier du modèle Santiago) Comprends: cousus.
GARANTIE SUR LA TOILE QUI EST PROTÉGÉ PAR CETTE GARANTIE Cette garantie protège l'acheteur d'origine de la toile Sunbrella. CE QUE PROTÈGE CETTE GARANTIE Cette garantie offre une protection quand la toile Sunbrella devient inutilisable en raison d’une perte de couleur ou de résistance aux conditions normales d'utilisation et d'exposition, incluant les rayons du soleil, la moisissure et les réactions chimiques atmosphériques.