Manual

Page 37 14439.C 03/2013
Patient Testing - 6
VerifyNow System User Manual | USA
9. If the test deviceistherstfromanewlot,theinstrumentwilldisplayabarcodescreenassoonas
the test device is inserted into the port and the spot code is read. (Figure 6-8). Place the test device
pouch in front of the bar code scanner on the left side of the instrument so that the bar code on the
bottom edge of the pouch lines up with the scanner window. Move the pouch both towards and away
from the instrument. An audible beep will be heard when the instrument reads the information. Press
the Retry keyifyouareunabletoscanthebarcodethersttime.
VerifyNow P2Y12
Use bar code
scanner to read
the bar code.
26-Feb-2012
14:57:00
Bar Code
After the bar code has been
scanned once, the instrument
will accept all remaining test
devices from that lot without
displaying the bar code screen.
Figure 6‑8 Scan Bar Code
NOTE:Ifyouareexperiencingdifcultyscanningthebarcode,tryadjustingtheangleofthescan
by raising the corner of the instrument.
10. Gentlyinvertthesampletubevetimestomixthereagents immediately before use (Figure 6-9).
Figure 6‑9 Invert Tube
5X
11. Wait for the Insert Tube icon to display, then insert the sample into the sample well of the test device
with the rubber stopper facing downward so that the needle pierces the stopper (Figure 6-10). The
instrument will produce two audible beeps when the tube has been fully inserted.
26-Feb-2012
VerifyNow P2Y12
14:57:00
Figure 6‑10 Insert Tube