Manual

Page 65 14439.C 03/2013
Cleaning and Maintenance - 9
VerifyNow System User Manual | USA
Procedure
Use a recommended cleaning solution on the exterior surfaces according to the following procedure:
1. Solutions may be applied by moistening a soft, lint-free cloth, and/or a cotton swab. Do not to allow
liquidstoowfreelyorbesprayedontheinstrument.
2. After cleaning with one of the solutions listed above, a cloth moistened with fresh water should be
used to dilute and remove all of the residual cleaning solution from the instrument’s surfaces.
3. Wipe the EQC device with a damp cloth moistened with isopropyl alcohol.
CAUTION:Donotsprayorpourcleaninguidsnearthetestdevice port
orotheropenings.Introductionofuidsintotheinteriorcandamagethe
VerifyNow instrument.
CAUTION: Do not steam-sterilize or autoclave the instrument. Do not
immerse the instrument in any solution. Do not clean the instrument with
acetone or any other plastic solvent or abrasive cleaner.
CAUTION: Prolonged exposure to alcohol or other strong cleansers
can result in damage or discoloration to the instrument’s case materials.
Always use a soft cloth when cleaning the display screen and bar code
window. Abrasive cleaners, pads, or cloths will permanently damage the
surface of the plastic windows.
CAUTION: Be careful not to spill any liquids on the instrument, printer
(accessory), or power supply while cleaning the exterior surfaces.
9.3 Replace the Fan Filter
The instrument is equipped with an exterior fan vent to cool the internal electronic components.
Depending on the room conditions, small amounts of dust and debris may accumulate over time
withinthefanlterandobstructairow.Periodiccleaningofthefanltermaybeperformedtoavoid
overheating of the instrument.
Fan Fan Filter
Fan Retainer
Materials
• Replacement fanlter (Accumetrics Catalog No. 37056)
• Replacement fanlterretainer (Accumetrics Catalog No. 37060)
Procedure
Use the following procedure to remove and clean the fanlter:
1. Power off the instrument (“O” designates off).
2. The fanlterisheldinplacebyapresstretainer.Usingyourngernailorasmalltool(e.g.
paperclip),gentlypullfromthecenterofthelterretainer(Figure9-4).