Use and Care Manual

3. Set the heater’s thermostat by pressing the arrows on

the control panel (Figure C) or the TEMP UP or TEMP

DOWN buttons on the remote control (Figure B).

You can set the temperature anywhere between 50°F

and 90°F (10°C and 32°C). Once you have chosen the

desired temperature, the heater will remain on until

the room temperature increases to the temperature

on the heater’s digital display. The heater will cycle on

and off to maintain the desired room temperature.

To view the ambient (room) temperature press the

ambient temperature button on the control panel.

Press the C°/F° button on the control panel (Figure C)

for five seconds to switch the digital display indicator

on the heater between Fahrenheit and Celsius.

4. To set the timer-power-off-mode, start the unit and

press the TIMER button on either the control panel

(Figure C) or remote control (Figure B).

Note: The timer-power-off-mode can only be set when

the heater is on.

The digital display on the control panel (Figure C)

changes from the temperature to a time value for the

timer. Press the TIMER button repeatedly to change

the number value between 0 and 12 hours (in one

hour intervals).

The Timer light turns on when the timer is set.

5. To set the timer-power-on-mode, while powering off

the unit, press the TIMER button on the panel

(Figure C).

Note: The timer-power-on mode can only be set when

the heater’s power is off.

The digital display on the control panel (Figure C)

changes from the set temperature readout to a time

value for the timer. Press the TIMER button repeatedly

to change the number value between 0 and 12 hours (in

one hour intervals).

The Timer light turns on when the timer is set.

C B

TIMER