User manual

CAN-CR2xx - Manual, V2.0

Installation

4 Installation

To operate the CAN-Repeater, no software installation is required.

Before you use the CAN-Repeater following points have to be paid attention:

- configuration of the bus termination

- configuration of the baudrate

- configuration of the lock time

More detailed information to these points can be found in chapter 3.

4.1 Mounting a single CAN-Repeater

Prior to mounting the device it has to be assured, that the device is not

connected to power.

In Picture 4-1 mounting of a CAN-CR220 is shown.

Picture 4-1 Mounting of an CAN-CR220

Put the upper

groove on the

DIN rail

2 Turn the device as

shown to lock the

lower mechanical

interlock