Manual

Connections
11 (26)
Low-Profile Version
Fig. 3 Low-profile version
In the low-profile version, only the D-Sub 9 connector of CAN 1 is implemented. It is possible to
output the signals of CAN 2 to a second slot bracket.
► To connect the second slot bracket to the interface, plug the ribbon cable in connector (1)
on the interface and in the connector on the second slot bracket.
6.3 Expansions
The fieldbus expansion connectors can be used to extend each CAN circuit with fieldbus
expansions for additional fieldbuses (exclusively galvanically isolated interfaces). The signals of
the additional fieldbuses are applied to the corresponding CAN connector.
The CAN expansion board connector can be used to connect a CAN expansion board that can
provide up to two additional CAN interfaces and fieldbus expansions.
1
PC CAN Interface User Manual
4.01.0230.20000 3.2 en-US