Instruction Manual

Charging Swami Watch

1. Place Swami Watch on charging station, make sure when docking the unit the black

arrow highlight in red on the charging station below (Image A) is pointing up toward the

buckle of the watch. Unit should rest in slot of charging station. (Reference Image B)

2. Plug charging station AC adapter into outlet. Next, press the left side button in toward

the watch until it locks into place. (Reference Image B). To release watch from charging

station press button in top right corner of charging station highlight in red (Image B).

3. Swami Watch has begun charging when the screen below (Image C) is shown. The

3 bars located in the battery icon will blink when charging. When fully charged, the

battery bars will stop blinking. Full charge takes about 4-5 hours.

Charging Swami Watch

usb connect

Image A Image B

Image C

Charging Station

Note: If screen shown to the right (Image C)

is not shown on swami watch while locked in

charging station, the watch may not be properly

placed in charging station. Make sure watch is

placed as shown in the instructions above.

Note: Charging station can charge the watch

through your computer by using the USB

end of the USB cable. Plug into USB port of

your computer to charge unit this way.