Operation Manual

1
Car alarm control
1) By remote-control
Depending on the installation, the car alarm can either be controlled with an RC-8x car alarm controller,
see paragraph a), or with an original remote control used for locking the car, see paragraph b). Please fol-
low the article which corresponds to the type of installation in your car.
a) By RC-8x car alarm controller
Setting: The car alarm is set by pressing a button on the remote control. If a central
locking system is installed, the car is concurrently locked.
Partial setting: When the remote control button
is pressed repeatedly (within 15 seconds
of alarm setting), partial setting takes place (confi rmed by an acoustic signal).
The inside of the car is not guarded by wireless internal detectors and so
neither a voltage drop detector nor any supplementary detectors are activated.
Unsetting the car alarm: The car alarm is unset by pressing a remote control button
. If the car is
equipped with a central locking system, it is concurrently unlocked.
The buttons on the right side of the controller can also be used (programmed) for different functions – e.g.
the remote control of garage doors, gates, light in the garage or house, etc. More information is available
from the installer or from the manufacturer.
b) By the original car remote control
Setting: When the car is locked with its remote control, the car alarm is set
concurrently.
3
T2711 - Jablotron - Manuál Atho3 3T2711 - Jablotron - Manuál Atho3 3 8.4.2009 13:27:118.4.2009 13:27:11