Rack Conveyor Dishmachine Maintenance Instructions Heater Replacement 07610-003-12-01 A October 14, 2005
www.jacksonmsc.com Jackson rack conveyor machines come equipped with heaters to ensure proper ware washing results. Occasionally, some of these components may need replacing to maintain optimum performance. Jackson offers all of the repair parts necessary for performing this task. The instructions provided here are for maintenance personnel only. Unauthorized persons should not attempt any of the steps contained in these instructions. STEPS 1. Remove the front dress panel. 2.
www.jacksonmsc.com 9. Remove the gasket. Removing silicone from thermostat well 7. With the thermostat probe out of the way, use the 1/2” socket and ratchet to remove the nuts holding the heater to the tub. Remove all nuts and lockwashers. Removing the gasket 10. Before proceeding any further, it is important to verify that the tub wall is free of any excess debris so that when the new gasket is applied, there are no gaps that could lead to leaking around the heater. 11.
www.jacksonmsc.com Putting the thermostat probe in the heater well 14. Apply silicone to seal the well and hold the thermostat probe in place. Three phase wiring 16. Using the torque wrench or a torque nutdriver (if available) torge the nuts holding the wires, jumpers and bus bars to 16 in-lbs. Tightening the nuts holding the power lines Applying silicone to the heater well 15.
www.jacksonmsc.com CONTACT INFORMATION 22. Replace the heater box cover. 23. Replace the front dress panel. AFTER MAINTENANCE ACTIONS Service perosnnel may want to drain the machine and allow it to cool down. Secure power to the unit at the service breaker and then verify the torque of all fasteners covered in this instruction. Jackson MSC Inc. provides technical support for all of the dishmachines detailed in this manual.