User Manual

j a c l o i n d u s t r i e s | 129 Dermody Street Cranford, NJ 07016

p 908.653.4433 | 800.852.3906 f 908.653.1717 | 800.852.4133 JACLO.COM

PG 10

CREATED 5.2014

(5) Reassemble Thermostatic Valve & Diverter



 A.  ReassembleinreverseorderofstepsinFig.2



  i. Inspectandremoveanydebrisindiverterbody.

  ii. Insertdivertercartridgeintobodysoprotrusiononcartridgetsintoholesinbodylocatedinthe

 6o’clockposition.SeeFig.2a

  iii. Installdiverterlocknutusing1"wrench,tightennut.

  iv. Inspectandremoveanydebrisinthethermostaticvalvebodycartridgeandcheckstopcavities.

  v. Applysiliconegreasetotheo-ringsonthethermostaticcartridge,insertcartridgeintovalvebody

   rotatingbackandforthslightly.Orientcartridgewiththenotchupinthe12o’clockposition.SeeFig.5.

  vi. Installthermostaticcartridgelocknutusing1¼"wrench,tightennut.

  vii. Reinstallhotandcoldcheckstops,rotatingbackandforthlightlyuntilseated.

  viii. Installhotandcoldcheckstopnutsusing13/16"wrench,tightennuts.

SLEEVE

SPINDLE

OPEN

CLOSED

Figure 5