Installation Guide

Pure Air

Bath

Page 12 www.jacuzzi.com Installation and Operation

English

 Installtheunit,insertingtheblowerendrst,

lowering the bathtub into the opening as shown in

the illustration (Figure 9).

 DONOTuseplumbingxturesorlinestolowerthe

unit. Allow the bathtub to rest on the supports.

Drop-in Installation (con’t)

FlatSuboor

Scrap Lumber

Figure 11 - Support

Figure 10 - Support

Figure 9 - Drop-In (side view)

Minimum2˝

(50mm) Max

Thickness

Tile or

Finished

Surface

Member Support

Substrate

 Inspectallttings,plumbing,andcontrol

lines after inserting the bathtub to insure the

components are not damaged, disconnected, or

contactingthenishsurfacesubstrateorsupport

members.

 Connectexwatersupplylinestofaucetandplug

power cords into GFCI outlet.

Remove scrap lumber and lower the bathtub fully

into the opening (Figures 10 and 11).

The bathtub must be fully supported from the

bottom.Thebathtubmustrestonthesuboor,or

be in contact with the leveling material.

Align the bathtub and connect the drain.

Turn on the power supply to the dedicated GFCI

protected circuits and check system operation.

Caulk around the perimeter of bathtub to seal

thespacebetweentherimandthenisheddeck

(Figure 7 on previous page).

Uneven

Suboor

Floating

Floor

Compound