Installation Guide

Pure Air
®
Bath
Installation and Operation www.jacuzzi.com Page 13
English
Undermount Installation
1
 Installdrain/overowaccordingto the manufacture’s
instructions.
Watertight installation of the drain is the installer’s
responsibility. Drain leakage is excluded from the Jacuzzi
Luxury Bath warranty of this product.
2
Turn off power supply to dedicated GFCI protected
circuits.
3
Install the unit in desired location. DO NOT use plumbing
xturesorlinestocarryorlowertheunit.
4
 Inspectallttings,plumbing,andcontrollinesafter
inserting to insure the components are not damaged or
disconnected.
5
Align the bathtub and connect the drain.
6
Insulation may be placed within the bathtub surround.
Provide adequate ventilation around the blower to ensure
sufcientairowandcooling.Donotblockblower
intake for any reason. Do not insulate the blower for any
reason. Keep blower clear of all debris.
7
 Cutdeck/countertotusingtheundermounttemplate
provided as follows:
•
Position the template so that the desired undermount
guidelines are aligned with the rim edge as shown
(Figure 12).
•
Using a grease pencil, mark the center lines (denoted
by on template). Remove template.
•
Measurethedistancefromthewall,orotherxedpoint
to the center lines (Figure 13).
8
 Afxcountertobathtub.Cleananydirtordebrisfromthe
top of the bathtub rim. Apply a bead of silicone sealant
around the entire rim of bathtub.
Do not use an adhesive or adhesive sealant to secure
the counter to the bathtub. If maintenance or remodeling
is required, the counter may have to be removed.
Adhesive will permanently bond the counter to the
bathtub. Carefully position the deck/counter over the
bathtub. Follow manufacturer’s instructions to determine
cure time.
9
Apply a continuous bed of silicone sealant around
the entire seam between the counter and the bathtub
rim. Allow sealant to cure according to manufacturer’s
instructions.
10
Turn on the power supply to the dedicated GFCI
protected circuits and check system operation.
Template
Bathtub Rim
Figure 12 - Template Placement
A
B
C
D
TemplateCounter
Figure 13 - Distance Measurement
Cleanup
To avoid dulling and scratching the surface of the bathtub, never use abrasive cleaners. For most soiled surfaces, a
mildliquiddetergentandwarmwaterissufcient.Thefollowingisalsorecommended:
•
Remove spilled plaster with a wood or plastic edge. Spots left by plaster or grout can be removed if lightly rubbed
with detergent on a damp cloth or sponge. Do not use metal scrapers, wire brushes or other metal tools, as they
will damage the bathtub’s surface.
•
Paint,tar,orotherdifcultstainscanberemovedwithFantastik®orsoapywater.
•
Minorscratcheswhichdonotpenetratethecolornishcanberemovedbylightlysandingwith600-gritwet/dry
 sandpaper.Youcanrestoretheglossynishtotheacrylicsurfaceofthebathtubwithaspecialcompound,
Meguiar’s #10 Mirror Glaze. If that is not available, use automotive rubbing compound followed by an application
of automotive paste wax.
•
Majorscratchesandgougeswhichpenetratetheacrylicsurfacewillrequirerenishing.CallJacuzziLuxuryBath
 tondaserviceagentinyourarea.