Installation Guide

Pure Air
®
Bath
Installation and Operation www.jacuzzi.com Page 15
English
Decrease Speed
Press the (-) button to decrease blower speed.
There are 8 blower intensities. Each push and release
of the (-) button will decrease blower intensity through 8
incremental steps. The indicator lights display intensity of
blower power.
Low
1-2
Medium
Low 3-4
High
7-8
Medium
High 5-6
With the blower ON, press the wave button to cycle
the blower from its minimum setting to a user dened
maximum.
The cycle from minimum to maximum completes in 6.4
seconds. The indicator lights will display the blower intensity
as it cycles from minimum to maximum. To turn off wave
mode, press the wave button.
Press the (+) or (-) button while in wave mode to set the
maximum intensity level from 50%-100%. There is a 5
second delay after adjusting the maximum intensity level
before changes are observed.
Wave Mode
Pulse Mode
With the blower ON, press the pulse button to cycle
between off and a user dened maximum.
Theblowerwillcycleon(1.5seconds)totheuserdened
maximum (1.5 seconds). All four indicator lights will blink. To
turn off pulse mode, press the (pulse) button.
Press the (+) or (-) button while in pulse mode to set the
maximum intensity level from 50%-100%. There is a 5
second delay after adjusting the maximum intensity level
before changes are observed.
If the wave or pulse functions do not immediately operate
when the wave button or pulse button is pressed, you may
beinchromatherapylightingmode,youmustrstpress
blower button to switch to blower operation.
These lights will
be blinking
Your air bath is designed to provide different massage experiences based on selected blower intensity. You can
generally expect the following:
Setting 1 – only the Thermal Lumbar Comfort (TLC) areas (inverted U on backrests) will be active
Setting 2 – the TLC area and most of the perimeter will be active
Setting 3 – the TLC area and all of the perimeter will be active
Setting 4 – all air channels will be active, including TLC, perimeter, and bottom
Settings 5-8 – all air channels active
•
4 lights on = High settings 7 and 8
•
3 lights on = Medium low settings 5 and 6
•
2 lights on = Medium high settings 3 and 4
•
1 light on = Low settings 1 and 2
Alternately, if the (-) button is depressed and held, the
blower intensity will decrease through each of the 8
blower intensities, stopping when the button is released.