Operation Manual

30
q
ew
Darning Stitch
q Stitch pattern: 27
w Thread tension dial: 3 to 6
e Presser foot: Automatic buttonhole foot R
• Starting to sew
z Pull the button holder q to the back.
x Place the garment under the foot. Press the needle
up/down button twice. Move the fabric to the
left to draw both threads under the foot.
c Lower the foot and start the machine.
The machine will lock stitch, sew 16 rows of darning,
lock stitch again and stop automatically.
v Turn the fabric and repeat sewing.
q Button holder
w Starting point
e 3/4˝ (2 cm)
r 9/32˝ (0.7 cm)
q
w
e
r
w
• Sewing a shorter darning
To sew a darning shorter than 3/4˝ (2 cm), first stop the
machine after sewing the required length y, then press
the reverse stitch button t.
The required length y has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
t Reverse stitch button
y Required length
u Starting point
• Sewing a same-sized darning
Simply start the machine to sew another darning at the
same size.
t
y
u
z x c v
i
• Adjusting the evenness of the darning
Correct the evenness of the darning as follows:
Press the cursor buttons to move the cursor under
the value “d5” i (default setting).
When the right side of the darn is lower than the left side,
press the button to set the value to “d6”–“d9”, and
make the darn even.
When the left side of the darn is lower than the right side,
press the button to set the value to “d1”–“d4”, and
make the darn even.