Operation Manual

8
Threading Bobbin Case
1 Place the bobbin into the bobbin case.
Make sure the thread unwinds in the direction of arrow.
2 Pull the thread into the bobbin case slot.
3 Draw the thread under the tension spring and into the
delivery eye.
* Leave about 10 cm (4") of free thread.
Winding the Bobbin
1 Draw the thread from spool.
Guide the thread around the bobbin winder thread guide.
2 Insert the thread through the hole in the bobbin from
the inside to the outside.
Put the bobbin on the bobbin winder spindle.
3 Push it to the right.
4 With the free end of the thread held in your hand,
depress the foot control.
Stop the machine when the bobbin has made a few
turns, and cut the thread close to the hole on the
bobbin.
5 Depress the foot control again.
When the bobbin is fully wound, stop the machine.
Return the bobbin winder spindle to its original position
by moving the spindle to the left, and cut the thread.
Note : Return the bobbin winder spindle when the machine
stops.
1
2
3
4
5
1
2
3