Manual

17 of 24

INSTALL A PAIR OF CABLE GUIDES ONTO THE DRIVE PIPE.

1. Slip a pair of cable guides on to the drive pipe.

2. Position the cable guides with the large discs next to each other.

3. DO NOT tighten these to the drive pipe at this point.

CONTINUE DPC-A STRUT, ASSEMBLY, DRIVE PIPE SEGMENTS, SPLICES

AND CABLE GUIDES FOR THE REMAINING PARTS.

1. Assure that you are maintaining level drive pipe center line AFF throughout the process.

2. Each remaining DPC-A should be 11’ from the last.

VERIFY THAT THE DRIVE PIPE FULLY ASSEMBLED TURNS FREELY

ALONG IT’S LENGTH.

SECURE THE DRIVE PIPE TO THE WINCH

1. Drill through the drive pipe using the holes on the drive pipe collars.

2. Secure with ½-13 x 4” Bolts, washers and nylon lock nuts.

CUT ANY EXCESS DRIVE PIPE FROM DRIVE PIPE SEGMENT ONE.

1. Allow for a min of 8” exposure before cutting away excess.