PARTYBOX 710 OWNER’S MANUAL
IMPORTANT SAFETY INSTRUCTIONS For all products: 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not block any ventilation openings. Install this apparatus in accordance with the manufacturer’s instructions. 6. Do not install this apparatus near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. 7. Do not defeat the safety purpose of the polarized or groundingtype plug.
English point-to-point and non-point-to-point operation as appropriate. (iv) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 52505350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.
TABLE OF CONTENTS 4 IMPORTANT SAFETY INSTRUCTIONS 2 9. SPECIFICATIONS 14 1. INTRODUCTION 5 10. TROUBLESHOOTING 14 2. WHAT’S IN THE BOX 5 11. COMPLIANCE 15 3. PRODUCT OVERVIEW 6 12. TRADEMARK 15 3.1 TOP PANEL 6 3.2 BACK PANEL 6 4. PLACEMENT 7 5. POWER ON 8 6. USING YOUR PARTYBOX 8 6.1 BLUETOOTH CONNECTION 8 6.2 USB CONNECTION 9 6.3 MUSIC CONTROL 9 6.4 AUX CONNECTION 10 6.5 MIXING SOUND WITH A MICROPHONE AND / OR GUITAR 10 6.6 CHARGING YOUR MOBILE DEVICE 11 7.
English 1. INTRODUCTION 2. WHAT’S IN THE BOX Congratulations on your purchase! This manual includes information about PartyBox 710 speakers. We encourage you to take a few minutes to read this manual, which describes the product and includes step-by-step instructions to help you to set up and get started. Read and understand all the safety instructions before using your product.
8) 3. PRODUCT OVERVIEW • • 3.1 Top Panel • Press to turn light effect on or off. Hold for more than 2 seconds to turn strobe light on or off. Rotate clockwise / counterclockwise to switch between different light patterns. 9) Mobile device dock Caution: – 9 Do not look directly at the light-emitting parts when the speaker lights are turned on.
English 4) Microphone/guitar volume knob (for ) • Adjust volume of the corresponding microphone ( guitar (if connected). ) or 4. PLACEMENT Caution: – 5) • Connect to a microphone or guitar. • IN/OUT Daisy-chain multiple PartyBox speakers through 3.5 mm audio cables (not supplied). 6) Do not sit or lean on the speaker or push it sideways to avoid tipover and possible damages. Place the speaker on a flat, stable surface and ensure that the rubber feet side is down.
5. POWER ON 6. USING YOUR PARTYBOX Cautions: Notes: – – Use the provided power cords only. ON 2 OFF – – Only one sound source can be played at a time. The priority order is USB -> BLUETOOTH -> AUX. Starting a source with higher priority will always interrupt a source with lower priority. To start a source with lower priority, stop the source with higher priority first. 6.1 Bluetooth Connection You can use the speaker with your Bluetooth enabled smartphone or tablet. 1 1. Connect AC power. 2.
English To reconnect the Bluetooth enabled device: • When you turn on this speaker next time, it tries to reconnect the last connected device automatically. • If not, manually select “JBL PartyBox 710” on your Bluetooth device to connect. 6.3 Music Control 6.2 USB Connection x1 x2 x3 • • • • • Press once to pause or resume playback. Press twice to skip to the next track. Press three times to skip to the previous track.
6.4 AUX Connection 6.5.1 Connecting a Microphone 1 2 1. Connect a microphone to the or 2. When connecting a microphone to the the slider to show . 1. Connect an external audio device to the speaker through a 3.5 mm audio cable (not supplied). 6.5.2 Connecting a Guitar 2. After stopping playback from any other source, start audio playback on the external device. 6.
English 6.5.3 Mixing Sound Sing through the microphone or play guitar. • To adjust the volume of the audio source, rotate the volume knob clockwise or counterclockwise. • To adjust the volume of the microphone or guitar, rotate the corresponding microphone or guitar volume knob. • To adjust the gain of the wired microphone or guitar, rotate the corresponding GAIN 1 or GAIN 2 control respectively.
8. ADVANCED USAGE 8.3 TWS Mode 8.1 Light Effect You can connect two PartyBox speakers to each other via TWS mode. x1 2S Press TWS on both speakers. To exit TWS mode: Power off or press TWS on either speaker. Tip: – • • • Press to turn light effect on or off. Hold for more than 2 seconds to turn strobe light on or off. Rotate the knob clockwise / counterclockwise to switch between different light patterns: Rock, Flow, Cross, Ripple, or Flash.
English 8.5 Daisy Chain 8.7 IPX4 Caution: – – Always keep the port dry before connecting AC power. To ensure splash resistance, always keep the protective covers closed securely. The speaker is IPX4 splash resistant. 8.6 Factory reset To restore the factory settings, hold seconds. and for more than 10 www.jbl.
9. SPECIFICATIONS Transducers: 2 x 216 mm (8") woofer, 2 x 70 mm (2.75") tweeter Caution: – Never try to repair the product by yourself. If you have any problems while using this product, check the following points before you request service. Output power: 800 W RMS (IEC60268) Power input: 100 – 240 VAC ~50 / 60 Hz Frequency response: 35 Hz – 20 kHz (-6 dB) System Signal-to-noise ratio: > 80 dB Cable type: right-angle AC power cable (type varies by regions) The speaker will not turn on.
English 11. COMPLIANCE 12. TRADEMARK The product is in compliance with the European Union energy legislation. Bluetooth connection mode The product is intended to be used for streaming music via Bluetooth connection. A consumer can stream Bluetooth audio to the speaker. When the product is connected through Bluetooth, the Bluetooth connection must remain active at all times to ensure proper operation. The product will enter sleep mode (networked standby) after 20 minutes without operation.
Este produto está homologado pela Anatel, de acordo com os procedimentos regulamentados para avaliação da conformidade de produtos para telecomunicações e atende aos requisitos técnicos aplicados. Para maiores informações, consulte o site da Anatel – www.anatel.gov.br Este equipamento não tem direito à proteção contra interferência prejudicial e não pode causar interferência em sistemas devidamente autorizados.
Активная акустическая система Изготовитель: Харман Интернешнл Индастриз Инкорпорейтед, США, 06901 Коннектикут, г.Стэмфорд, Атлантик Стрит 400, офис 1500 Сделано в Китае Импортер: OOO “ХАРМАН РУС СиАйЭс“, Россия, 127018, г.Москва, ул. Двинцев, д.12, к. 1 Гарантийный период: 1 год Срок службы: 2 года Информация о сервисных центрах: www.harman.
