User's Manual
7 Series “i” Set Up Instructions
7SeriesInstalledModelsSetUp Page6 8/1/16
Double-click on the speaker tuning icon for the channel(s) you
would like to configure. Select the particular tuning needed on a
per-amplifier channel basis.
After clicking the icon, you will see the following speaker tuning panel. On this speaker tuning panel, select
“Recall.”
You will be presented with a list of speaker models. Select the preset for the desired speaker model.
The following presets are provided for 7 Series and also JBL M2 Speakers:
o LSR705i: LSR705i Single wire tuning
o LSR708i: LSR708i Single wire tuning
o LSR705i LF LSR705i Bi-Amp Tuning (Woofer)
o LSR705i HF LSR705i Bi-Amp Tuning (Tweeter)
o LSR708i LF LSR708i Bi-Amp Tuning (Woofer)
o LSR708i HF LSR708i Bi-Amp Tuning (Tweeter)
o M2 HF JBL M2 HF
o M2 LF JBL M2 LF NoHP – Full Range LF
o M2 LF JBL M2 LF HP27 –Includes High Pass Filter at 27Hz (Recommended)
If you plan to use the speakers in bi-amplified mode, you will use bi-amp speaker tuning presets – one for
the Tweeter and one for the Woofer.
NOTE: You will need to configure the amplifier channels for bi-
amplified operation. After selecting the speaker tuning preset,
navigate back to the DCi Control Panel. To create a bi-amplified
amplifier configuration, double click the “Mode” button in the
amplifier control panel.