Installation Guide

ManualsBrandsJBL ManualsloudspeakersJBL SLP 12-T Sleek Low-Profile Wall-Mount Loudspeakers

Installation Guide

SLP 12/T and SLP14/T

Sleek Low-Profile Wall-Mount Loudspeakers

CAUTION: Installation must be done by qualified

persons using safe installation standards.

The installer is responsible for proper selection and use of

mounting hardware to install the speakers in a safe manner.

Wiring Loudspeaker

• MULTI-PIN CONNECTOR -- Attach one or two pairs of wires to included multi-pin connector. Tighten

set screws. Securely press multi-pin connector into matching socket in loudspeaker’s terminal

compartment. Inside the speaker, both “+” terminals are connected in parallel and both “–“

terminals are connected in parallel to allow, allowing parallel connection to next loudspeakers in a

distributed loudspeaker system.

MULTI-PIN

CONNECTOR

TERMINAL

COMPARTMENT

Summary of content (5 pages)

PAGE 1
Installation Guide SLP 12/T and SLP14/T Sleek Low-Profile Wall-Mount Loudspeakers CAUTION: Installation must be done by qualified persons using safe installation standards. The installer is responsible for proper selection and use of mounting hardware to install the speakers in a safe manner. Wiring Loudspeaker • MULTI-PIN CONNECTOR -- Attach one or two pairs of wires to included multi-pin connector. Tighten set screws.
PAGE 2
• TERMINAL COVER -- Add TERMINAL COVER, if desired, using included tapping screws. For improved sealing of TERMINAL COVER, installer-supplied silicone glue or other suitable sealant can be applied to cable opening of TERMINAL COVER. TERMINAL COVER (4 included attachment screws, 6mm flat cross-head tapping x 10 mm) Routing Wiring (Wire Management) • The back panel sits flush to the wall. Recesses are provided for routing the wires in either the upward or downward direction.
PAGE 3
Setting TAP SELECTOR SWITCH TAP SELECTOR SWITCH . • Rotate back-panel TAP SELECTOR SWITCH to select between: o SLP12/T: 8Ω (ie, low-impedance / direct) 15W, 7.5W, or 3.8W for either 70V or 100V distributed speaker system 1.9W for 70V distributed speaker system only o SLP14/T: 8Ω (ie, low-impedance / direct) 25W, 12.5W, or 6.3W for either 70V or 100V distributed speaker system 3.
PAGE 4
Installing WALL-MOUNT BRACKET to Wall and LOUDSPEAKER to Bracket • Use appropriate screws or bolts for the wall material and wall construction to securely attach WALLMOUNT BRACKET to wall. • Slide LOUDSPEAKER down onto Wall Bracket until fully engaged. • Attach installer-supplied secondary safety cable (with ring lug end) to M6 SAFETY CABLE ATTACHMENT INSERT POINT using installer-supplied M6-1.0 x 10 mm (max depth of the threaded insert) bolt through the ring lug at end of safety cable.
PAGE 5
Harman Professional Singapore 108 Pasir Panjang Road #02-08 Golden Agri Plaza Singapore 118535 +65 6870-5000 www.harman.com Harman Professional India Prestige Technology Park Jupiter 2A Block, 4th Floor Marathahalli Ring Road Bangalore 560103, India +918049365905 www.harman.com Harman Professional Shenzhen 20F, China Merchants Port Plaza, #1 Gongye 3rd Road, Shekou, Nanshan Dist. Shenzhen, 518067, China +86 755 8634 3702 www.harman.