Instructions / Assembly

Lamp Assembly Drawing

After the lamp body is installed and hung, the crystal lampshade and light

source are installed.

Remote control: power input. Ground terminal of the first port. N is input

zero line, l is input live wire, motor line is divided into: pink, gray, red,

three lines. Connect according to the remote control. Light source line:

l is connected to the fire line. N is connected to the lamp zero line.

The lamp source line is gold wire.

The hanging plate is fixed at the position where the lamp needs to be hung

Fix the bottom cover at the bottom and fasten the smooth head.

。

Lock the hanging plate on the top of the middle rod and fix it with screws.

Put in the bell, pay attention to the direction

Insert the horn into the center lever. Pay attention to the direction

Lock the pin, fix the middle rod, and pay attention to the direction of the

middle rod. And fix the middle rod screw

Put the middle rod into the T-shaped hanging plate and fix the screws

Fasten the T-shaped hanging plate above the lamp cover and tighten it. and

lock the screws

Cover the lamp

Install the lamp arm on the lamp, pay attention to the direction of the lamp

arm, and lock the hexagon screw

PAGE 1
La mp As s embl y Dr a wi n g I n s t a l lt he l a mp a r m on t he l a mp,pa ya t t en t i on t ot he di r ect i on oft he l a mp a r m,a n dl ock t he hexa gon s cr ew Covert he l a mp F a s t en t he T-s ha ped ha n gi n g pl a t ea bove t he l a mp covera n dt i ght en i t .a n d l ock t he s cr ews Pu tt he mi ddl er od i n t ot he T-s ha ped ha n gi n g pl a t ea n df i xt he s cr ews Lock t he pi n ,f i xt he mi ddl er od,a n d pa ya t t en t i on t ot he di r ect i on oft he mi ddl er od.