Instructions / Assembly

INSTALLATION INSTRUCTIONS
for Aluminum Windows without Nailing Fin (JII031)
5
© 2009 JELD-WEN, inc. | JELD-WEN and Reliability for real life are registered trademarks of JELD-WEN, inc., Oregon USA.
All other trademarks are the property of their respective owners.
Please visit jeld-wen.com/resources for warranty and care
and maintenance information.
Thank you for choosing
(03/09)
1. Create a continuous
air seal on the
interior by lling the
gap between the
rough opening and
the window frame
with low expansion
polyurethane foam
or backer rod and
sealant.
2. On the exterior,
apply backer rod and
sealant between the
window frame and
the rough opening
(not applicable to
ush n windows).
AFTER INSTALLATION
Ensure weep holes/channels are clear of debris for proper water •
drainage; do not seal weep holes/channels if present.
Adjust window for best operation.•
Protect recently installed units from damage from plaster, paint, etc. •
by covering the unit with plastic.
2. Fasten window
through a side jamb
3"-6" from one lower
corner as follows:
Apply sealant to a.
the screw and
drive through the
pilot hole.
Cover the screw b.
head with sealant.
3. Inspect window
for square, level
and plumb (adjust
shims or remove and
reinstall if necessary).
4. Fasten window in
a similar manner
through the remaining corners, and then through the rest of the
fastener locations.
IF INSTALLING A FINLESS WINDOW
Place window onto
the shims and tilt into
the rough opening.
The window sill
must rest on and be
supported by the shims.
Continue with “ALL
INSTALLATIONS.”
ALL INSTALLATIONS
1. Shim the side jambs at each pre-drilled hole. Shims must be set at
least 1/4" back from the interior of the window frame. Secure shims
with sealant. Secure shims with sealant.
INSTALL WINDOW - CONTINUED
5
6"
8"
Interlock
Center
Shim
Jamb
Rough
opening
1/4" Sealant gap
1/4" Sealant gap
Interior
Jamb
Cutaway
From Top
Screw
with sealant
COMPLETE INSTALLATION
6
Sealant
joint
Backer
Rod
Gap