Installation Guide

14
2. Remove the access cover at the back of the grill by removing
the 4 screws at the back of firebox (2 on each side of the
rotisserie infrared burner).
3. Using a Phillips screwdriver, remove the 2 screws holding the
spider guard to the burner.
4. Use 24 mm wrench to remove the orifice nut.
5. Take out the orifice support, and then use a 6 mm socket and
wrench or 6 mm nut driver to remove the LP orifice at the end
of the supply pipe. Replace with Natural gas orifice.
6. Reinstall the spider guard, access cover, and wind baffle.
Change the Infrared Searing Main Burner Orifices
1. Remove the screw securing the infrared searing main burner
igniter and remove the igniter from the searing burner.
2. Remove the infrared searing main burner cover screws. Set
the screws and cover aside.
A. Access cover
A. 2 screws
A. Orifice nut
A
A
A
A. Orifice support
B. Orifice
A. Screw
A. 2 screws
A
B
A
A