NN-AIR Sealed Gas Cooktop Models CCG2421, CCG2521 Use and Care Manual Model CCG2421 Printed in U.S.A. @1999 Jenn-Air Part No.
Read before operating your cooktop All appliances - regardless of the manufacturer- havethe potential through improper or careless use to create safety problems. Therefore the following safety precautions should be observed: 1. Be sure your appliance is properly installed and grounded by a qualified technician. 2. Never use your appliance for warming or heating the room. This warning is based on safety considerations. 3. Children should not be left alone or unattended in area where appliance is in use.
14. Do not touch surface burner areas or any areas near burners. During and after use, these areas may be hot enough to cause burns. Avoid contact with these areas by clothing or other flammable materials until they have had sufficient time to cool. 15. Do not heat unopened food containers. Build-up of pressure may cause container to burst and result in injury. 16. Keep all controls "OFF" when unit is not in use. 17. GREASE - Grease isflammable and should be handled carefully.
IMPORTANT SAFETY NOTICE AND WARNING , The California Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65) requires the Governor of California to publish a list of substances known to the State of California to cause cancer or reproductive harm, and requires businesses to warn customers of potential exposures to such substances.
Whenthe control knobis turned ON, gas will flow intothe burner. The solid state igniter will click as long as the knob is in the Lite position. (Note: All burner igniters will spark regardlessof which burner is being operatedwhen a knob isturned to the Iite position.) A properly adjusted burner with clean ports will light within a few seconds. On natural gas, the flame will be blue with a deeper blue inner core. There should be no trace of yellow in theflame.
• Since the controls are a push-turn type, they must be pushed down before turning. To set (from the OFF position), push down on control knob and immediately turn counterclockwise to the Life setting. After the burner lights, turn the knob to the desired flame size. • Igniter wil_ spark until knob is turned counterclockwise past the Hi position. CAUTION: If flame should go out during a cooking operation, turn the burner off.
To achieve optimum cooking performance, use cookpots with flat bottoms,tight fitting covers, and sized for the surface burner. • Flame size should be adjusted so it does not extend beyond the edge of the cookware. This instruction is based on safety considerations. Adjusting the size of the flame to fit the size of the cookwarealso helps to save fuel.
Check the following list to be sure a service call is really necessary. If surface burner fails to light: • check to be sure unit is properly connectedto power supply. • check for a blown circuit fuse or a tripped main circuit breaker. • check to be sure burner is correctly rated for your type of gas. • check to be sure burner ports or ignition ports are not clogged. • check to be sure igniter is clicking, If igniter doesn't click, turn control knob OFF, If the flame is uneven: • burnerportsmay be clogged.
Be sure all controls are OFF and all cooktop parts are cool before cleaning. The cooktopisdesignedwith contouredwells which containspills untilthey canbe wiped up. Neverwipe a warm or hot porcelainenamel surfacewith a dampcloth. For general daily cleaning and light soil, wash with warm soapy water, rinse, and dry. To remove greasespatters, spray with cleaners such as Fantastikor 409. DO NOT use abrasive or caustic cleaning agents which may permanently damage the finish.
• The sealed burners are secured to the cooktop and are NOT designed to be removed.Since the four burners are sealed into the cooktop, boilovers won't seep underneathto the burner box area. Thus, there are no hidden spills in the burner box area to clean. • Clean with warm soapy water and a sponge or dishcloth. Burned on grease can be removedwith a householdcleaner, such as Fantastikor 409, and a sponge. To prevent scratching,do not use abrasive cleaners or scrubbing pads.
Model Number Serial Number (Serial Plate is located on the bottom side of the cooktop.) Date Purchased JENN-AIR DEALER FROM WHOM PURCHASED Address city. Phone AUTHORIZED JENN-AIR SERVICE CONTRACTOR Address City_ Phone Important: Retain proof of purchase documents for warranty service.
