Installation guide

SINGLE
See side clearance--------)l
note below.
'" L ,,I, ,,
- ;- r-_ 4 3t4"
Min. I 1 I 12.ol cm
Clearanoe ]J-----1_ *
Required ,._,, [] _ Grease
17 1/2" I II 1 I I Container
44"46cm [__,,_ LJSEENOT E
--_-- 12 1/2 -_ BELOW
31.76crn
4,
t"
K SEENOTE
BELOW
DOUBLE
See side clearance_I _ _-
note below.
Min.
Clearance ,,.
Required
17 1/2"
44.46 cm
IIILli
I _fl _- J SEE NOTE
_12 1/2L-_ BELOW
31.76cm
4,
1"
K SEE NOTE
BELOW
TRIPLE
See side clearancei-----) I
note below
k-
i i ii
.in
Clearance-" _-_11z116_._tl I IlL.
;,_::ircemd 29 06cm17 1/2" i1_"m SEE NOTE
B ELOW
30 t/8"
76.52 cm
-'_ 3/4"
12.01cm
{
$
1"
K SEE NOTE
BELOW
Instructions For Installer:
• Save installationinstructions for local inspector'suse.
° Leave installation instructions with the appliance.
• Refer to "installer Installation Suggestions" on page 3 before cutting.
• Dimensions shownin both inchesand centimeters
• Consult ductingguidefor properinstruction,
• Dimensions "A" & "B" - tolerances +/-t/16" or +/-.16 cm.
• Dimension "J" - provide2" rain (5.08 cm) cabinetclearance to motorfor coolingpurpose.
NOTE:Where possible,6" (15,24 cm) is recommended for motor blower service.
• Dimension "K" - provide6-1/4" (15.88 cm) requiredfor removal of (supplied)grease container(s).
Installed dimensionfor (supplied)grease container(s)is5-1/2" (!3.97 cm)
• Side Clearance - grillsinstallednear a sidewall must allowa minimum clearance of 6" (15.24 cm) between cooktop
and sidewallfor maximum performance.Minimumclearance of 1" (2.54 cm) is required to sidewallsand 314"
(1905 cm) to rear wall.
• Electrical Hookup - the unit must be properlycircuitprotectedand wiredaccordingto localelectricalcodes, See
electrica!wiringinformationon page 3. Unit power requirementsare !ocated on the serial plate.