Installation guide

2_0Eawar_sE,tr_e[ %
C'.m:e,anaTe.nr_z_ee_7._11
Fax_2._-478-_70
16. CONNECT ELECTRICAL (FOUR CONDUCTOR WIRE)
- CAUTION: Make sure power to cable is OFF.
- Remove the range electrical service cover located on the back, lower left-hand corner. Remove the
ground strapscrew and bend the strap up as shown.
- [nstall a 3/4 (1.19 cm) cable clamp in the hole provided, below the terminal block.
- Strip 3" (7.62 cm) of outer insulation from the cable.
- Strip lt2" (1.27 era) of insulation from each wire.
- Pull the cable through the cable clamp.
- Make a loop in the bare ground wire and attach it to the range with the screw that held the _m'ound
strap.
- Attach the BLACK, RED, and WHITE wires (see #15). Tighten the terminal block nuts and the
cable clamp.
- Tape the ground strap to the WHITE wire as shown. Installelectrical cover.
, _ 'WlRI::
17. INSTALL Ot_IONS
- If a backsplash or side panels are to be used, install according to instructions included with those
accessories.
18. POSITION RANGE
a
.==,=,=.,=_ \
i
|
J
- Free-Standing: Adjust the range feet so the range and cabinet height wil! be approximately the
same. Slide the range into place, taking care not to damage floor coventlg.
- Slide-In: Carefully lift and place the range on the cabinet top.