Installation Instructions

INTRODUCTION | 5
INTRODUCTION
SITE PREPARATION
BEFORE INSTALLATION
IMPORTANT:
 These instructions are intended as a
general guide only and do not supersede
any national or local codes in any way.
Compliance with all local, state, or national
codes pertaining to this type of installation
should be determined prior to installation.
 These instructions are intended to
supplement the Installation Instructions
provided with your refrigerator, not replace
them. Follow the instructions provided with
the refrigerator to install it into the cabinet.
NOTE: The hardware bag contains all
the parts and fasteners needed to install
panels. Most of these components have
been pre-installed on the panels included in
this kit. A hardware bag is shipped with the
refrigerator. You will nd the hardware bag in
either one of the crisper drawers or attached
to the outside of one of the refrigerator
doors.
Pinch Hazard
Installation of door panels with less than a ³⁄₈"
(0.95 cm) gap between the door panel and the
adjacent cabinet increases the risk of potential
pinching.
CAUTION
TOOLS AND PARTS REQUIRED
Assemble the required tools and parts before starting
installation. Read and follow the instructions provided
with any of the required tools listed here. Proper
installation is your responsibility.
Tools Required:
 Cordless drill and drill bits
 3/8" and 1/2" Open-end wrenches or two
adjustable wrenches
 Phillips screwdriver
 Small level
 Appliance dolly
 3/32", 5/32", and 3/16" Hex keys
 1/4" and 5/16" Nut drivers
 6" Extension nut drivers
 Tape measure
TOOLS AND PARTS PROVIDED
Parts Supplied with Panel Kit:
 Exterior door panels with handles and
mounting hardware pre-installed.
 Instructions
Grille Panel Grille bracket assembly
Foam air divider
Parts Supplied with Refrigerator
(Needed to Install Panel Kit):
Phillips-head at screw
Black: 8281252
Slotted hex-head screw
W10141645
Door stop pin
W10234202