Installation instructions

2
INSTALLATION REQUIREMENTS
Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Parts Supplied
All of the following parts are provided, but not all parts will be
used. The cutout opening size will determine which parts you will
use. See the chart following the illustrations of the parts to see
which parts are used for each installation.
*Extension plate (B) will have to be removed from side bracket (A)
for this installation.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■ Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with oven.
■ Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
■ Grounded electrical supply is required. See “Electrical
Requirements” section.
■ Oven support surface must be solid, level and flush with
bottom of cabinet cutout. Floor must be able to support an
oven weight of 111 lbs (50 kg).
IMPORTANT: To avoid damage to your cabinets, check with
your builder or cabinet supplier to make sure that the
materials used will not discolor, delaminate or sustain other
damage. This oven has been designed in accordance with
the requirements of UL and CSA International and complies
with the maximum allowable wood cabinet temperature of
194°F (90°C).
Undercounter Installation (with cooktop installed above):
Ovens approved for this type of installation have an approval
label located on the top of the oven. Refer to undercounter
installation instructions for cutout dimensions and approved oven
cooktop combinations (a separate sheet).
■ Measuring tape
■ Pencil
■ T10 TORX
®†
screwdriver
■ Electric drill
■ ⁵⁄₆₄" (2 mm) drill bit
A. Side brackets (2)
B. Removable extension plates
(shaded piece, 2)
C. 1" T10 screws (6)
D. Narrow side trim panels (2)
E. Wide side trim panels (2)
INSTALLATION PARTS USED
24" (61.0 cm) installation C
27" (68.6 cm) installation* A, C, D
30" (76.2 cm) installation A, B, C, E
A
B
C
D
E
†®TORX is a registered trademark of Saturn Fasteners, Inc.