Installation Manual
Table Of Contents
- Introduction
- VARIANTS AND ACCESSORIES
- INSTALLATION REQUIREMENTS
- INSTALLATION INSTRUCTIONS
- Introduction
- VARIANTES ET ACCESSOIRES
- EXIGENCES D’INSTALLATION
- Outils et pièces
- Dimensions du produit
- Dimensions pour l’ouverture des portes
- Préparation du site
- Exigences d’emplacement
- Spécifications de l’alimentation en eau
- Spécifications électriques
- Exigences d’installation de l’ensemble de panneaux en acier inoxydable
- Exigences d’installation et dimensions des panneaux de bois personnalisés
- INSTRUCTIONS D’INSTALLATION
- Déballage du réfrigérateur
- Déplacement du réfrigérateur dans le domicile
- Raccordement à la canalisation d’eau
- Brancher le réfrigérateur
- Installation des garnitures latérales
- Déplacement du réfrigérateur à son emplacement définitif
- Réglage de l’aplomb et alignement du réfrigérateur
- Installation de la grille de la base
- Terminer l’installation
13
STAINLESS STEEL PANEL KIT
INSTALLATION REQUIREMENTS
Refer instructions received with full height door panel kit.
CUSTOM WOOD PANEL DIMENSIONS
AND INSTALLATION REQUIREMENTS
Refer instructions received with Armoire kit.
INSTALLATION INSTRUCTIONS
UNPACK THE REFRIGERATOR
IMPORTANT :
Do not remove the film covering until the refrigerator
is in its operating location.
All four leveling legs must contact the floor to support
and stabilize the full weight of the refrigerator.
Keep the cardboard shipping piece or plywood under
the refrigerator until it is installed in the operating
location.
1. Remove and save the literature package and
hardware kit located inside the refrigerator. Remove
and save the literature, grille, and trim taped to the
outside of the refrigerator.
NOTE : Do not remove tape and door bracing until
the refrigerator is in its final location.
MOVE THE REFRIGERATOR INTO HOUSE
1. Place an appliance dolly under the left side of the
refrigerator as shown. Place the corner posts from
the packing materials over the trims as appropriate.
Slowly tighten the strap.
2. Place pieces of the shipping carton on the floor when
rolling the dolly and refrigerator into the house. Move
the refrigerator close to the built-in opening.
3. Place top of cardboard carton or plywood under
refrigerator. Stand the refrigerator up. First, place the
left bottom edge of the refrigerator on the floor, stand
the refrigerator upright and then lower the right-
hand side of the refrigerator to the floor.
4. Reassemble the trim and top grille after the dolly has
been removed from the refrigerator.
CONNECT THE WATER SUPPLY
Read all directions before you begin.
IMPORTANT :
If you turn the refrigerator on before the water line is
connected, turn the ice maker OFF.
Connect to potable water supply only.
CONNECT TO WATER LINE
PARTS NEEDED
Minimum 7 ft (2.13 m) flexible, codes-approved water
supply line.
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.