Installation Manual
Table Of Contents
- Introduction
- VARIANTS AND ACCESSORIES
- INSTALLATION REQUIREMENTS
- INSTALLATION INSTRUCTIONS
- Introduction
- VARIANTES ET ACCESSOIRES
- EXIGENCES D’INSTALLATION
- Outils et pièces
- Dimensions du produit
- Dimensions pour l’ouverture des portes
- Préparation du site
- Exigences d’emplacement
- Spécifications de l’alimentation en eau
- Spécifications électriques
- Exigences d’installation de l’ensemble de panneaux en acier inoxydable
- Exigences d’installation et dimensions des panneaux de bois personnalisés
- INSTRUCTIONS D’INSTALLATION
- Déballage du réfrigérateur
- Déplacement du réfrigérateur dans le domicile
- Raccordement à la canalisation d’eau
- Brancher le réfrigérateur
- Installation des garnitures latérales
- Déplacement du réfrigérateur à son emplacement définitif
- Réglage de l’aplomb et alignement du réfrigérateur
- Installation de la grille de la base
- Terminer l’installation
16
PLUG IN REFRIGERATOR
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a similar
qualified person. Do not use a cord that shows cracks or
abrasion damage along its length or at either the plug or
connection end.
1. Set control switch at top of cabinet to the OFF
position.
2. Plug into a grounded 3 prong outlet.
INSTALL SIDE TRIMS
The side trims cover the space between the refrigerator
and the adjacent cabinets. There is a trim piece taped to
each side of the refrigerator. Install each trim piece to the
side of the refrigerator to which it is taped.
1. Remove the tape attaching the trim pieces to the
sides of the refrigerator. Set the trim pieces aside.
2. Remove the four screws from the side of the
refrigerator cabinet.
3. Using the original holes and the screws removed in
Step 2, fasten the side trim to the refrigerator cabinet.
NOTE : Make sure to fasten each trim piece to the
side of the refrigerator cabinet from which it was
removed. The tapered shaped edge should be
forward with the notches aligning with the door
hinges.
TOP VIEW
MOVE REFRIGERATOR TO FINAL
LOCATION
IMPORTANT :
A flush installation is NOT possible with a
24" (60.9 cm) deep opening.
To avoid floor damage, make sure levelers are raised
(not touching floor) and refrigerator is on rollers
before moving.
Use the installation block, attached to the door hinge,
as a reference to make sure the refrigerator is pushed
back far enough into the opening, so that when
the panels are installed they will be flush with the
adjacent cabinets.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
A
A. Side trim screws
A
B
C
A. Side trim
B. Adjacent cabinet
C. Door
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.