Installation guide

ManualsBrandsJenn-Air ManualsRangeOfficial Jenn-Air dual-fuel range

INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE

INSTALLATION MANUAL

Dual Fuel 30-inchWide Free-StandingRange

PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE

THE MANUAL IS INTENDED TO ASSIST IN THE INITIAL INSTALLATION AND ADJUSTMENTS OF THE RANGE.

Only qualified personnel should

install or service this range.

Read "Safety Instructions" in the

Use & Care book before using

range.

Improper installation, adjustment,

alteration, service, maintenance or

use of range can result in serious

injury or property damage,

WARNING

• ALL RANGES CAN TIP AND

CAUSE INJURIESTO PERSONS.

• INSTALL ANTI-TIP DEVICES

PACKED WITH RANGE.

• FOLLOW ALL INSTALLATION

INSTRUCTIONS.

Your range may not be equipped with

some of the features referred ;€oin this

manual,

CLEARANCE DIMENSIONS

Range may be installed with zero inches clearance

adjacent to (against) combustible construction at the rear

and on the sides below the cooktop. For complete

information in regard to the installation of wall cabinets

above the range and clearances to combustible wall

above the cooking top see the installation drawings. For

SAFETY CONSIDERATIONS do not install a range in any

combustible cabinetry which is not in accord with the

installation drawings.

* NOTE: The 30 inch (76.2 cm) dimension may be

reduced to not less than 24 inches (61 cm) when the wall

cabinets in a domestic home are protected with fireproof

materials in accordance with American National

Standards - National Fuel Gas Code or in mobile homes

when they are protected with fireproof materials in

accordance with the Federal Standard for Mobile Home

Construction and Safety.

To eliminate the risk of burns or fire by reaching over

heated surface units, cabinet storage space located

above the surface units should be avoided. If cabinet

storage is to be provided, the risk can be reduced by

installing a range hood that projects horizontally a

minimum of 5 inches (13 cm) beyond the bottom of the

cabinets.

CAUTION: This range has been designed in

accordance with the requirements of various safety

agencies and complies with the maximum allowable

wood cabinet temperatures of 194°F. If this range is

installed with cabinets that have a lower working

temperature than 194°F, discoloration, delamination

or melting may occur. Contact Customer Service

for associated cabinet dimensions and installation

accessories.

8101 P729-60

(03-06-00)

Summary of content (10 pages)

PAGE 1
INSTALLER: LEAVE THESE INSTRUCTIONS WITH INSTALLATION THE APPLIANCE MANUAL Dual Fuel 30-inch Wide Free-StandingRange PLEASE KEEP THIS MANUAL THE MANUAL IS INTENDED FOR FUTURE REFERENCE TO ASSIST IN THE INITIAL INSTALLATION AND ADJUSTMENTS CLEARANCE Only qualified personnel should install or service this range. Read "Safety Instructions" in the Use & Care book before using range.
PAGE 2
INSTALLATION DRAWINGS Note: Diagramis for newinstallation.Preexistingstructures may need modificationfor properinstallation. GASANDELECTRICAL SUPPLYSHOULDNOTCONVERGE. DONOTGROUNDELECTRICALSUPPLYTOGASSUPPLYUNES, NOTE: TO ENSUREFLUSH TO WALL INSTALLATIONGAS SERVICE INCLUDING SHUT-OFFVALVESHOULDNOTPROTRUDEMORETHAN3" (7,6CM)FROMREARWALL PROVIDE FOB 1201208 VOLT 1201240 VOLT FLUSH OUTLET PER APPLICABLE IN THIS AREA "A" : 30" (76.2 CM) - 31" (78,7 CM) FOR CANADA "B" : 3 I/4" (8.3 CM) - 3 314" (9.
PAGE 3
(SEE NOTE ON fRONT PAGE) ANY COMBUSTIBLE SURFACE 30" {76,? CM) +3" (33 CM) WAXIMU_ DEPTH OF CABINETS ABOVE COOK TOP O" {0 CW) CLEARANCE BETWEEN ADJACENT COMBUSTIBLE SURFACES AND THE BACK AND SIDES OF THE RANGE, BELOW THE COOKING SURFACE 3G" (91.
PAGE 4
ANTI-TIP DEVICE INSTALLATION INSTRUCTIONS NOTE: A risk of range tip over exists if the appliance is B, not installed in accordance with the installation instructions provided. The proper use of this device minimizes the risk of TIP-OVER. In using this device the consumer must still observe the safety precautions as stated in the USE and CARE MANUAL and avoid using the oven door and/or lower drawer as a step stool. 1. Installation instructions are provided for wood and cement in either floor or wall.
PAGE 5
CONNECTING ELECTRIC THE RANGE SUPPLY by local code. USE COPPER OR ALUMINUM CONDUCTORS. Main terminal block is recognized for Copper or Aluminum conductors. If a flexible power cord is required, it is recommended a cord no longer than 4 ft. be used. Make connections as explained below and with reference to the appropriate illustration (see figures 6 and 7). After installation, insure tightness of all electrical connections and replace all covers.
PAGE 6
CONNECTING FIGURE 4 3-Wire Service THE RANGE Cord or Conduit Installation 1. Insure that the copper ground strap IS CONNECTED between the middle post of the main terminal connection block and the range chassis. post of the main terminal block. The other two wires of the service cord or conduit connect to the outside posts of the main terminal connection block. Polarity is unimportant. If using bare wire, attach wire to appropriate lug as shown. Torque specifications are shown below. 2.
PAGE 7
CONNECTING THE RANGE FIGURE 5 4-Wire Service Cord or Conduit Installation (Mobile Homes Or As Required By Codes) 1. The copper ground strap connected between the neutral (middle) post of the main terminal block and the chassis MUST be cut off as shown in figure 5. Save the green ground screw to attach the ground from the 4 wire cord. Only a 4 wire cord or conduit should be used. appropriate lug as shown. Torque specifications are shown below. 5.
PAGE 8
CONNECTING THE RANGE excess of 1/2 Ibs./sq. in. (3.5 kPa) (13.8 in. water column). Gas Supply 2. The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 Ibs./sq. in. (3.5 kPa) (13.8 in. water column). Installation of this range must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.
PAGE 9
RecommendedGas Supply Connections a. REGULATOR SHUT-OFF VALVE ON OFF b. REGULATOR A GAS CUTOFF VALVE SHOULD BE PUT IN AN ACCESSIBLE LOCATION IN THE SUPPLY LINE AHEAD OF THE RANGE, FOR TURNING ON AND TURNING OFF GAS SUPPLY. If range is to be connected to house piping with flexible or semi-rigid metal connectors for gas appliances, CONNECTOR NUTS MUST NOT BE CONNECTED DIRECTLY TO PIPE THREADS. THE CONNECTORS MUST BE INSTALLED WITH ADAPTORS PROVIDED WITH THE CONNECTOR.
PAGE 10
RANGE ADJUSTMENTS GAS CONVERSION Top Section - Electric Ignition SEE INSTRUCTIONS LOCATED ON THE To operate, push and turn top burner knob to the LITE position. The top burner will light. To turn OFF spark after the top burner has ignited, turn knob to Ht setting. NOTE: Top burners are not adjustable. Air Shutter - Bake/Broil Burner NOTE: If oven burner does not ignite, check oven gas shut-off position at the regulator. a.