Owner's Manual
Table Of Contents
- OVEN SAFETY
- PARTS AND FEATURES
- BEFORE USING THE OVEN
- ELECTRONIC OVEN CONTROL
- OVEN USE
- Aluminum Foil
- Wire Shelf and Other Accessories, Shelf Guides, Sliding Runners
- Water Container
- Temperature Probe
- Oven Vent
- Assisted Cooking
- Cooking Modes - Steam
- Cooking Modes - True Convect
- Cooking Modes - True Convect+Steam
- Specialty Functions - Steam Defrost
- Specialty Functions - Steam Reheat
- Specialty Functions
- OVEN CARE
- TROUBLESHOOTING
- ASSISTANCE OR SERVICE
- SÉCURITÉ DU FOUR
- PIÈCES ET CARACTÉRISTIQUES
- AVANT D’UTILISER LE FOUR
- COMMANDE ÉLECTRONIQUE DU FOUR
- UTILISATION DU FOUR
- ENTRETIEN DU FOUR
- DÉPANNAGE
- ASSISTANCE OU SERVICE
6
Settings
You can control several settings through the Settings Menu:
Temperature Units, Language, Time, Display Brightness, Signal
Volume and Eco Mode.
To access the Settings Menu, press the up or down buttons until
“Settings” is selected on the display, then press OK to conrm.
Language
The language must be set on the display after power is supplied
to the oven.
To Set the Language:
1. Press ON/HOME.
2. Press the up or down buttons until “Settings” is selected on
the display, then press OK to conrm.
3. Press the up or down buttons until “Language” is selected
on the display, then press OK to conrm.
4. Press the up or down buttons until the desired language is
selected on the display, then press OK to conrm.
5. Press BACK to exit the settings function when you are done.
Time
The time must be set on the display after power is supplied to
the oven or after a power failure.
To Set the Time:
1. Press ON/HOME.
2. Press the up or down buttons until “Settings” is selected on
the display, then press OK to conrm.
3. Press the up or down buttons until “Time” is selected on the
display, then press OK to conrm.
The digits on the display will icker.
4. Press the up or down buttons until the correct time is
displayed, then press OK to conrm.
5. Press BACK to exit the settings function when you are done.
Brightness
To Set the Brightness of the Display:
1. Press ON/HOME.
2. Press the up or down buttons until “Settings” is selected on
the display, then press OK to conrm.
3. Press the up or down buttons until “Brightness” is selected
on the display, then press OK to conrm.
4. Press the up or down buttons until the desired brightness is
selected on the display, then press OK to conrm.
5. Press BACK to exit the settings function when you are done.
Volume
To Set the Signal Volume:
1. Press ON/HOME.
2. Press the up or down buttons until “Settings” is selected on
the display, then press OK to conrm.
3. Press the up or down buttons until “Volume” is selected on
the display, then press OK to conrm.
4. Press the up or down buttons until the desired volume is
selected on the display, then press OK to conrm.
5. Press BACK to exit the settings function when you are done.
Temperature Unit
The temperature unit default is Fahrenheit, but it can be changed
to Celsius.
To Set the Temperature Unit:
1. Press ON/HOME.
2. Press the up or down buttons until “Settings” is selected on
the display, then press OK to conrm.
3. Press the up or down buttons until “Temperature Unit” is
selected on the display, then press OK to conrm.
4. Press the up or down buttons until the desired temperature
unit is selected on the display, then press OK to conrm.
5. Press BACK to exit the settings function when you are done.